- 11 -
EN
Menu operation function list (cont.)
Menu items Purpose Settings
Signal
Setting
Other
Power Lamp
Duration
Transparency
Status Display
Volume
Reset
Information
Select the signal source.
H Position Adjust the OSD horizontal position.
Adjust the OSD display time.
Language Select the OSD language.
Adjust the OSD transparency.
Select for display of the signal input
connector name.
Adjust audio volume level.
Reset the menu settings.
*Reset operation is required for each input source.
Show the input connector name and
signal source name.
Select the power indicator setting.
* ON : In conjunction with the power indicator is lit.
* OFF : The power indicator is not enable.
PC-VGA / DVI / HDMI
On / Off
On / Off
Digital / Analogue / Off
Off / On
On / Off
On / Off
0 - 100
V Position Adjust the OSD vertical position. 0 - 100
0 - 7
3 sec - 60 sec
On / Off
0 - 100
On / Off
Aspect Setting Select the aspect ratio.
Source Search
Select the On to set the monitor is searching
automatically the input source.
Select the On to set the monitor to turn
into Stand-by mode if no operation
condition continues for about 4 hours.
Auto / Full / 4:3
No Operation
Action
No Sync Action
Source Select
Audio
Assign
PC-VGA
DVI
HDMI
Select Off to set the monitor to mute sound.
Select Off to set the monitor to mute sound.
Select audio input source.
English / Deutsch / Français
/ Español/日本語
OSD Menu
Select the On to set the monitor to turn
into Power saving mode , if no sync
condition continues for about 15 seconds.
*1 This feature dose not work by setting the Color ADJUST to “DICOM SIM”.
*4 This feature dose not work by setting the DCR to “On”.
*2 If you select except Japanese in the Language setting of the First Time Installation menu,
Language is changed "English".
*3 This feature works , when you are viewing the "HDMI (Video) signal".
This feature does not work , when you are viewing the "HDMI (PC) signal".
*2
*2
B5A-0998-00xxx.pdf11 2015/10/0617:03:38
To Next Page
Loading...
Need help?
General
