15
T
W
T
W
T
W
T
W
FEATURE: Zooming
PURPOSE: Varies the focal length of the lens and
produces the zoom in/out effect.
OPERATION:
Zoom In
1) Pull the power zoom switch down
toward “T”.
Zoom Out
2) Push the switch up toward “W”.
NOTES: ●
The further the power zoom switch is
pushed, the faster the zoom speed
becomes.
●
Focusing may become unstable
during zooming. In this case, set the
zoom while in Record–Standby, set
manual focus or Focus Lock (
Z
pg.
20, 21), then zoom in or out in
Record mode.
FEATURE: Quick Review
PURPOSE: To check the end of the last recording.
OPERATION: 1) Press “
” for less than 2 seconds
during the Record–Standby mode.
• Tape is rewound for about 2
seconds and played back
automatically, then pauses in
Record–Standby mode for thenext
shot.
NOTE:
Distortion may occur at start of
playback.
This is normal.
FEATURE: Retake
PURPOSE: To re-record certain segments.
OPERATION: 1) Make sure the camcorder is in the
Record–Standby mode.
2) Press either RETAKE button to reach
the start point for new recording.
3) Press Recording Start/Stop to start
recording.
NOTE:
Noise may appear during Retake.
This is normal.
FEATURE: Index Code Marking
PURPOSE: To give you automatic access to any
selected point on a recording. Auto
Marking and Manual Marking are
available.
OPERATION:
Auto Marking
An index code is always marked to start
the first recording on a new date after a
cassette is inserted.
Manual Marking (Using the optional
RM-V700U Remote Control Unit)
1) Press VISS once to place the index
code. INDEX blinks in the viewfinder
during marking.
NOTES: ●
If VISS is pressed during
Record–Standby mode, the mark is
placed where START/STOP is
pressed.
●
If the date changes during a
recording, it becomes the first
recording of the new date and an
index mark is placed at that point.
RETAKE
Power zoom switch
Zoom-in
Zoom indicator
Zoom-out
RECORDING
Basic Features
START/STOP
VISS
RM-V700U (optional)
Downloaded from: https://www.usersmanualguide.com/
To Next Page
Loading...
Need help?
General
