JVC GR-D396US - Editing; Dubbing to a VCR

MasterPage: Heading0_Left
42 EN
EDITING
1Yellow to VIDEO IN
2Red to AUDIO R IN
3White to AUDIO L IN
To use this camcorder as a player
1 Following the illustrations, connect the
camcorder and the VCR’s input connectors.
2 Start playback on the camcorder. ( pg. 21)
3 At the point you want to start dubbing, start
recording on the VCR. (Refer to the VCR’s
instruction manual.)
4 To stop dubbing, stop recording on the VCR,
then stop playback on the camcorder.
NOTES:
● It is recommended to use the AC Adapter as
the power supply instead of the battery pack.
(
 pg. 15)
● To choose whether or not the following displays
appear on the connected TV
• Date/time
Set “DATE/TIME” to “ON” or “OFF”.
(
 pg. 31, 35) Or, press DISPLAY on the
remote control to turn on/off the date indication.
• Time code
Set “TIME CODE” to “OFF” or “ON”.
(
 pg. 31, 35)
• Indications other than date/time and time code
Set “ON SCREEN” to “OFF”, “LCD” or “LCD/
TV”. ( pg. 31, 35)
Dubbing To A VCR
TV
VCR
Audio/Video cable
(provided)
To AV
connector
GR-D396US.book Page 42 Friday, December 30, 2005 1:25 PM