JVC GR-DVL100U - Page 9

Display
Snapshot mode
RECORDING Basic Recording (cont.)
Snapshot
This feature lets you record still images that look like
photographs onto a tape.
SNAPSHOT MODE SELECTION
ff Sethe Power Switch to “BB” or “BB” while pressing
down the Lock Button located on the switch.
Fp Choos the appropriate Snapshot mode rom the 5
available-by repeatedly pressing MODE until the
desired snapshot mode indicator appears.
SNAPSHOT RECORDING
Press SNAPSHOT.
press during Record-Standby .
RTPHOTO" appears and a sill age willbe
recorded for approx. 6 seconds, then the
‘camcorder re-enters the Record-Standby mode.
#¥ you press during Recording
.. "PHOTO" appears and a sill mage will be
recorded for approx. 6 seconds, then the normal
recording resumes.
‘Motor Drive Mode
Keeping SNAPSHOT pressed provides an effect similar to
serial photography. (Interval between still images: approx.
1 second)
Analyzer 4
MULTI-9
‘Multi-Analyzer 9
PIN-UP
Pin-Up modet
* There is the sound effect of a shutter closing.
NOTES:
© Even if “MULTI-4” or “MULTI-9” is engaged, Snapshot
recording will be performed in the FULL mode during
Digital Zoom.
© if Snapshot recording is not possible, “PHOTO” blinks
when SNAPSHOT is pressed.
© if Program AE with special effects (CF pg. 28) is
‘engaged, certain modes of Program AE with special
effects are disabled during Snapshot recording. In such a
case, the icon blinks.
© If SNAPSHOT is pressed when *DIS” is set to “ON”
(CF pg. 24), the Stabilizer will be disabled.
© During playback as well, all Snapshot modes are
available. The shutter sound is not heard.
© During Snapshot recording, the image displayed in the
viewfinder may be partially missing. However, there is
ro effect in the recorded image.
© When a cable is connected to the AV connector, the
shutter sound is not heard from the speaker, however it
is recorded onto the tape.
‘© BEC will appear while the snapshot is being taken.