24
Stop Button (m)
I
VIDEO/DSC Switch
(CR-DVM75 only)
Power Switch
F&US/BLANK Button
Display
Blank Search
Helps you find where you should start recording in the
middle of a tape to avoid time code interruption
b pg. 20).
I
Load a tape (lo pg. 12).
Set the
VIDEO/DSC
Switch to “VIDEO” (GR-
DVM75 only), then set the Power Switch to U m”
while pressing down the Lock Button located on the
switch.
Press
FOCUS/BLANK.
*“BLANK SEARCH” appears blinking and the
camcorder automatically starts reverse or forward
shuttle search, then stops at the spot which is
about 3 seconds of tape before the beginning of
the detected blank portion.
To cancel Blank Search midway. . .
. . . .
press
n
NOTES:
l
In step 3, if the current position is at a blank portion the
camcorder searches in the reverse direction, and if the
current position is at a recorded portion the camcorder
searches in the forward direction.
0 Blank Search does not work if “HEAD CLEANING
REQUIRED. USE CLEANING CASSETTE” has appeared
with the tape.
l
If the beginning or end of the tape is reached during
Blank Search, the camcorder stops automatically.
l
A blank portion which is shorter than 5 seconds of tape
may not be detected.
l
The detected blank portion may be located between
recorded scenes. Before you start recording, make sure
there is no recorded scene after the blank portion.
To Next Page
Loading...
