46
EN :
IMPORTANT:
Some modes of Program AE with special
effects cannot be used with certain Fade/Wipe
Effects (w pg. 48, 49). If an unusable mode is
selected, its indicator blinks or goes out.
Program AE With Special Effects
4
Set the Power Switch to “@I” while pressing down
the Lock Button located on the switch. Open the
LCD monitor fully or pull out the viewfinder fully.
. PROGRAM AE Button
Display
PROGRAM AE
Menu
Press the MENU Wheel in. The Menu Screen
appears.
Rotate the MENU Wheel to select 0 l!Zl PROGRAM
AE”, then press it. PROGRAM AE Menu appears.
1 Rotate the MENU Wheel to select the desired mode
(rca= pg. 47), then press it. Selection is complete.
Press the MENU Wheel in again. The Menu Screen
closes.
Press PROGRAM AE.
*The selected mode indicator appears.
To Deactivate The Selected Mode . . .
. ..Press PROGRAM AE again so that the mode indicator
disappears.
NOTES:
l
Program AE with special effects can be changed during
recording or during Record-Standby
l
Some modes of Program AE Special Effects cannot be
used during Night-Alive 6~ pg. 45).
GR-DVM75 only
To Next Page
Loading...
