27
Audio Dubbing
You can record a new soundtrack on a prerecorded
tape (normal audio only). The sound is recorded
from the built-in microphone.
Perform steps 1) and 2) of the Insert Editing
procedure (
pg. 26).
3)Press REW
T to go a little beyond the beginning
of the scene onto which you want to dub the new
audio, press PLAY
R to view the recorded tape,
then press PAUSE
a at exactly the point where
dubbing should start.
4)While holding down A. DUB
s, press and
release PAUSE a.
5)To begin Audio Dubbing, press PLAY
R. When
the counter reaches “0:00:00”, Audio Dubbing
stops automatically and the camcorder enters
the Audio Dub-Standby mode. To end Audio
Dubbing, press STOP
Y.
• Do not press REW
T or FF P during Audio Dub-
Standby, or the edit points will not be accurate.
• If the microphone is too close to the TV, or if the
TV’s volume is too high, whistling or howling may
occur.
For Insert Editing/Audio Dubbing
• Insert Editing and Audio Dubbing may not work
correctly if the tape contains blank segments, or if
the recording speed was changed during the
original recording.
• To edit/dub onto a tape, make sure the erase
protection tab is in the position that allows
recording.
• Do not press STOP
Y during Insert Editing or
Audio Dubbing, or the edit points will not be
accurate.
GR-SXM600AS_EN_Malaysia 11/6/03, 02:32 PM27
Black
To Next Page
Loading...
