(No.YF137)1-17
SECTION 5
TROUBLE SHOOTING
5.1 SERVICE NOTE
[18]
3-2-4
[12]
3-2-3
[1] [2] [3] [4] [5] [6] [7] [8] [9] [10]
1 2 3 4 5 - 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
CA1 FA1 FA2
a
FA4
FA3 FA5
FA6 FA7 FA8
ab
ed
-
[11] [12] [13] [14] [15] [16] [17] [18]
25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49
FA9 UA1
aab c
UA2
UA3 UA4 FA10 FA11
1 2 3 4 5 6 7
1 2 3 4 5 6 7 8 9
Symbol No.
Removing order of screw
Place to stick screw
Reference drawing (Fig.No.)
Screw tightening torque
Symbol No.
Removing order of screw
Place to stick screw
Reference drawing (Fig.No.)
Screw tightening torque
Symbol No.
Removing order of screw
Place to stick screw
Reference drawing (Fig.No.)
Screw tightening torque
CABINET PARTS AND ELECTRICAL PARTS(1)
[12]MONITOR ASSY
CABINET PARTS AND ELECTRICAL PARTS(2)
[18]OP BLOCK ASSY/CCD BOARD ASSY
NOTE:
1 ) and (This mark shows where to attach the screws) : Do not reuse the screws because the screw lock bond was applied to prevent the screws from loosening.
Prepare the specified screws and use them in place of the removed screws.
2 )Tightening torque for the screws
There are setting limits of the torque value for the torque driver. If the value exceeds the setting value, take it as a rough measurement (reference value),
and tighten the screw manually.
The specified torque value is a recommended value of the initial assembly. Therefore, set the value below the specified torque value in the assembling procedure.
Be careful not to break either the screws or the screw holes.
a : 0.098N m (1.0kgf cm) b : 0.245N m (2.5kgf cm) c : 0.118N m (1.2kgf cm) d : 0.147N m (1.5kgf cm) e : 0.078N m (0.8kgf cm)
To Next Page
Loading...
