27
You can use a camcorder as the source player and your video
recorder as the recorder.
Edit From A
Camcorder
MAKE CONNECTIONS
1
To J438E Owners:
Connect the camcorder’s AUDIO/VIDEO OUT
connectors to the recorder’s front panel AUDIO/VIDEO
input connectors.
● When a Master Edit Control-equipped JVC camcorder
is used, the camcorder is capable of controlling the
recorder. Refer to the camcorder’s instruction manual
for operating procedure.
To J238E Owners:
Connect the camcorder's AUDIO/VIDEO OUT
connectors to the recorder's AV1 IN/OUT or AV2 IN
connector.
SET RECORDER’S INPUT
MODE
2
To J438E Owners:
Press NUMBER key “0”. “F-AU” appears in place of a
channel number.
To J238E Owners:
Press NUMBER key "0" or TV PROG. to select depend-
ing on the connector being used — "AU 1" for the AV1
IN/OUT connector, or "AU 2" for the AV2 IN connector.
● When using the AV2 IN connector, make sure the
AV2 SELECT switch is set to "AV2".
START CAMCORDER
3
Engage its Play mode.
START RECORDER
4
Engage its Record mode.
NOTE:
Connections made to the front panel AUDIO/VIDEO input
connectors automatically override those made to the rear panel
AUDIO/VIDEO input connectors. [J438E only]
6
q
VIDEO
IN
AUDIO
IN
EDIT
Player
VIDEO OUT
AUDIO OUT
Recorder
Your recorder
12
45
3
6
8
0
7
9
1
3
2
NUMBER "0"
Audio/Video Cable
(not provided)
To the rear panel PAUSE
connector [J438E only]
Editing Cable
(not provided)
To Next Page
Loading...
