JVC HR-S2902U User Manual

—1—
Page 1 November 11, 2002 2:18 pm
VIDEO CASSETTE RECORDER
HR-S2902U
INSTRUCTIONS
LPT0730-001A PrintedinChina
COPYRIGHT © 2002 VICTOR
COMPANY OF JAPAN, LTD. 1102 MNV
f
PJ
f
BJ
Dear Customer,
Thank you for purchasing the JVC S-VHS video cassette recorder.
Before use, please read the safety information and precautions to
ensure safe use of your new VCR.
CAUTIONS
.
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE
THIS UNIT TO RAIN OR MOISTURE.
CAUTION:
This video cassette recorder should be used with AC 120V
d
,
60Hz only.
To prevent electric shocks and fire hazards, DO NOT use any
other power source.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION:
POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA
LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE
CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU
FOND.
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s
attention to Article 820-40 of the NEC that provides guidelines
for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alert the user
to the presence of uninsulated “dangerous voltage”
within the product’s enclosure that may be of
sufficient magnitude to constitute a risk of electric
shock to persons.
The exclamation point within an equilateral triangle
is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the
appliance.
NOTE:
Change or modifications not approved by the party responsible
for compliance could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio TV technician for
help.
Caution on Replaceable lithium battery
The battery used in this device may present a fire or chemical
burn hazard if mistreated. Do not recharge, disassemble, heat
above 100°C or incinerate.
Replace battery with CR2032. Panasonic (Matsushita Electric)
or Maxell is recommended.
Danger of explosion or Risk of fire if the battery is incorrectly
replaced.
䡲 Dispose of used battery promptly.
䡲 Keep away from children.
䡲 Do not disassemble and do not dispose of in fire.
Declaration of Conformity
Model Number: HR-S2902U
Trade Name: JVC
Responsible Party: JVC Americas Corp.
Address: 1700 Valley Road Wayne, N.J. 07470
Telephone Number: 973-317-5000
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
HR-S2902U-EN-1.fm Page 1 Monday, November 11, 2002 2:19 PM

JVC HR-S2902U Specifications

General

Type	VCR
Recording Speed	SP, LP, EP
Playback Speed	SP, LP, EP
Remote Control	Yes
Number of Heads	4
Connections	Composite video/audio

Summary

Safety Warnings and Precautions

Electric Shock and Fire Hazard Warnings

Precautions against electric shock, rain, moisture, and plug insertion.

Lithium Battery Safety Guidelines

Handling, disposal, and safety instructions for the lithium battery.

FCC Compliance and Modification Notice

Information on FCC rules and warnings against unauthorized modifications.

Product Safety and Installation Guidelines

General Usage and Placement Safety

Instructions for VCR placement, ventilation, and accessory handling.

Installation Safety Procedures

Guidance on grounding, power sources, cord protection, and mounting.

Antenna Installation and Electrical Safety

Procedures for antenna grounding, lightning protection, and power line safety.

Product Care, Servicing, and Remote Operations

Usage and Environmental Precautions

Warnings on water, liquids, heat, attachments, and placement.

Servicing and Safety Check Instructions

Guidance on when to seek professional service and safety checks.

Remote Control and Video Head Maintenance

Instructions for remote use and video head cleaning.

VCR Placement and Mobile Interference

Advice on VCR placement near TVs and mobile phone interference.

VCR Controls, Display, and Connections

Front Panel Controls and Indicators

Identification of VCR front panel buttons, connectors, and indicators.

Remote Control Layout and Functions

Detailed layout and explanation of the remote control buttons.

Rear Panel Connections and On-Screen Display

Rear panel ports, on-screen indicators, and information recall.

Connections and Initial Plug&Play Setup

Connecting the VCR to Your TV

Instructions for RF, AV, and S-video connections.

Plug&Play Automatic Setup Process

Procedure for automatic clock and channel setup.

Troubleshooting Plug&Play Setup Issues

Steps to resolve problems encountered during Plug&Play setup.

Setting VCR Channel and Final Preparation

Setting the VCR's broadcast channel and final usage preparation.

Initial Settings and Clock Configuration

Language Selection Menu

How to choose the user interface language for menus and messages.

Semiauto Clock Setup Guide

Manually adjusting time, DST, and time zone settings.

Manual Clock Setting Procedure

Step-by-step guide to manually setting the clock, date, and year.

Tuning and Basic Playback Operations

Channel Tuning Methods

Automatic and manual procedures for setting TV channels.

Basic Playback Functions

Loading cassettes, starting, pausing, and searching playback.

Advanced Playback Features and Navigation

Tape Tracking and Audio Selection

Adjusting tape tracking and selecting audio monitor modes.

Automatic Rewind Functions

Setting auto playback start or power off after rewinding.

Locating Recordings and Skipping Content

Using Index Search, Instant Review, and Skip Search for navigation.

Recording Operations and Features

Recording Safety and Basic Steps

Preventing accidental erasure and loading cassettes for recording.

Recording Control and Modes

Starting, pausing recording, setting length, and S-VHS/VHS modes.

Recording Features and Audio Options

Recording other programs, second audio, and video calibration.

Timer Recording Management

Express Timer Programming Guide

Setting up timed recordings using the express method.

Managing Timer Program Settings

Checking, canceling, changing, and resolving program overlaps.

Additional Functions and Settings

Timer Warnings and Display Options

Timer warning display and changing on-screen information.

Function Set Menu Operations

Accessing and modifying various VCR functions like S-VHS ET and Picture Control.

Picture and Recording Adjustments

Settings for Video Calibration, Picture Control, and Auto Timer.

Advanced Function Settings and Child Lock

Display and Recording Mode Settings

SUPERIMPOSE, AUTO SP-EP TIMER, S-VHS MODE, VIDEO STABILIZER.

Audio and Input Selection Options

AUDIO MONITOR, 2ND AUDIO RECORD, FRONT AUX INPUT settings.

Child Lock Feature Operation

Enabling and disabling the VCR's child lock function.

Video Editing Procedures

Editing Connection Setup

Connecting VCRs for VHS and S-VHS editing.

Editing Process and Tape Methods

Steps for editing, including input selection and tape types.

Product Specifications and Accessories

General and Tuner Specifications

Power, dimensions, weight, operating conditions, and tuner details.

Video, Audio, Timer, and Accessory Details

Signal system, resolution, audio specs, timer capacity, and accessories.

Warranty Information and Support

Limited Warranty Coverage and Exclusions

Details of warranty period, what JVC covers, and what is excluded.

Warranty Service and Customer Information

How to obtain service, required documents, and customer details.

Service Center and Support Information

Warranty Repair Process and Service Center Location

Filling repair forms and finding the nearest service center.

Important Service and Accessory Advice

Advice on purchasing accessories and avoiding self-service.