EN 41
SPECIAL FEATURES
123
456
7
89
0
2
4
1
3
TV Multi-Brand Remote
Control
The VCR's remote control can control several functions on JVC
remote control TVs and on the brands of remote control TVs
listed below. *The default setting is JVC code 01.
TURN ON THE TV
1
Turn the power on using the TV's remote control.
SET TV BRAND CODE
2
Refer to the chart in the left column. While holding down
TV on the VCR's remote control, enter your TV’s brand
code using the NUMBER keys, then press STOP.
Follow the example shown below.
Check if the TV's power goes off as it should. If it does,
try other operations (Z step 3).
● Once you have set the remote control to operate the
TV, you don’t have to repeat this step until you
replace your remote control’s batteries.
● GRADIENTE and PHILICO have several codes. If the
TV does not function with one code, try entering the
other.
OPERATE TV
3
First, press TV to set the remote control to TV mode,
then press the corresponding button: , TV/VCR, TV
PROG +/–, TV +/– (Volume), (Muting),
NUMBER keys.
● For some brands of TV, you must press ENTER after
having pressed the NUMBER keys.
NUMBER
TV/VCR
TV BRAND NAME BRAND CODE
JVC 01
CCE 03
GRADIENTE 02, 11, 12, 16
GRUNDIG 14
LG/GOLDSTAR 11
MITSUBISHI 08
NEC 16
NOBLEX 18
PANASONIC 13
PHILICO 05, 09, 17
PHILIPS 03
RCA 12
SANYO 04
SAMSUNG 10
SHARP 06
SONY 15
TOSHIBA 07
(Ex.) To set remote control to RCA 12:
Press in succession
Hold
down
Release
NOTE:
Depending on the type of TV, there may be cases where some
or all functions cannot be operated using the remote control.
STOP
ENTER
TV
2
1
TV
+/–
TV PROG+
TV PROG–
Downloaded from: https://www.usersmanualguide.com/
To Next Page
Loading...
