To assembleandconnectthe AM loopantenna
To assemhle the AM loop antenna
To connect the AM loop antenna cords
@ Hold _ @ Release ,/
O) In sortbL>'_'_ Lqi
If the AM loop antenna wire or speaker cords are covered with
vinyl, remove the vinyl to expose the tip of the antenna by
twisting the vinyl.
• Make sure the antenna conductors do not touch any other
tenninals, connecting cords and power cord. Also, keep the
antennas away from metallic parts of the System, connecting
cords, and the AC power cord. This could cause poor
condition.
To connectthe speakercords
• When connecting the speaker cords, match the polarity of
the speaker terminals: (+) to (+) and ( ) to ().
• Use only speakers with the same speaker impedance as
indicated by the speaker tenninals on the rear of the unit.
each terminal.
Speaker
cords
(black/blue)
@ Hold @ Release
Speaker
cords
(black/blue)
From right speaker From left speaker
To connect digital audio
Beibre connecting optical digital cord, remove the
protective cap t'rom the OPTICAL DIGITAL OUTPUT
terminal.
To connectthe AVCOIVlPULINKcords
The AV COMPU LINK control system allows you to use
JVC's TV with simple operations; by starting playing back
a disc, the TV automatically rams on and changes the input
mode to the appropriate position so that you can view flae
playback picture.
To use AV COMPU LINK, you need to connect file unit and
flae TV by using a cord with monaural mini-plugs (not
supplied) in addition to the connection with a video cord (see
page 4).
To connect other equipment
By using an stereo mini plug coM (net supplied), you can
connect equipment with analog audio output ,jacks such as an
MD player, a TV, etc.
AUX Stereo mini plug cord (not supplied)
fCj_-_/_ 1 P°rtableaudi° I
_. _// device,
(front panel) Game, etc.
If the audio output on the other equipment is not stereo
mini plug type, use a plug adapter to convert the stereo mini
plug to the corresponding plug of the audio output.
Air, a3 s set xolume to MIN v,hen connectine or
d sconnect ng t ae other equ pment.
[
A DO NOT plug in any equipment until all
connections are complete.
6
To Next Page
Loading...
