5 Finish the setting.
Pop-up window goes oft'.
To cancel Repeat Play, select "OFF" ill step 4.
To erase the on-screen bar
ON
SCREEN
Time Search
You can move to a particular point by specifying tile elapsed
playing time from the beginuing.
1 While playing (without PBC for SVCD/VCD), display
the on-screen bar with the pull-down menu.
• Except for DVD: Time Search can be used before
starting playback.
2 Select [_ .
3 Display the pop-up window.
A-BRepeat
1 While playing, display the on-screen bar with the pull-
down menu.
2 Select _.
3 Display the pop-up windows.
4 Select "A-B".
5 Select the start point (A).
4 Enter the time.
You call specify tile time ill hourshninutes/seconds,
Examples:
To move to a point of 1 (hours):
02 (minutes): 00 (seconds), press
1,0, 2, 0, then 0.
To move to a point of 54
(minutes): 00 (seconds), press 0,
5, 4, 0, then 0.
• It is always required to enter the hour digit (even "0"
hour), but it is not required to enter trailing zeros (tile
last two digits in the examples above).
• To correct a misentry, press cursor < to erase tile last
entry.
5 Finish the setting.
The System starts playing from
the specified time.
Select the end point (B).
A-B Repeat starts. The selected
portion plays repeatedly.
Before pressing ENTER, you can
search for tile end point using IDa.
To erase the on-screen bar
ON
SCREEN
27
To Next Page
Loading...
