e!eeau!;ioa
Installation
• Install in a place which is level, dry and neither too hot nor
, o_ o _o
toocold between5 C(41 F) and3. C(95°F).
• Install the System in a location with adequate ventilation to
prevent internal heat buildup in the System.
DONOS
install the System in a location
near heat or in a place subject to
sources,
direct sunlight, excessive (lust or vibration.
• Leave sufficient distance between the System and the TV.
• Keep the speakers away from the TV to avoid interference
with TV.
Power sources
• When unphlgging tile System fi'om tile wall outlet, always
pull Oll the plug, not the AC power cord.
{ ...........................................................................................................................................................{
A DO NOT handle the AC power cord with
wethands
Moisturecondensation
Moisture may condense on tile lenses inside the System in
the lbllowing cases:
• After starting to heat the l'oom
• I11a damp 1"OOlll
• If the System is brought directly from a cold to a warm place
Should this occur, the System may malfunction. In this case,
leave the System turned Oll for a few hours until tire
moisture ewlporates, unplug the AC power cord, then plug
it in again.
Internal heat
• A cooling fan is mounted on tile rear panel to prevent heat
buildup itrside tile unit.
..... <
For safety,observe thefollowingcarefully:
• Make sure there is __ood ventilation around
the unit. Poor ventilation could overheat
A and damage the unit.
.DoNOTblockthecool,ngfanandthe
Others
• Should any metallic object or liquid fall into tire System,
unplug the AC power cord and consult your dealer before
operating any further.
DO NOT disassemble the System since there
are no user serviceable parts inside.
• If you are not going to operate the System for an extended
period of time, unplug the AC power cord from the wall
outlet.
If arrything goes wrong, unplug the AC power cord arrd
consult your dealer.
HeWtoRe d This Mahuat
To nmke the explanations in this nmnual as simple arrd easy-
to-understand as possible, we have adapted the following
methods:
• Button and control operations are explained as listed in the
table below. In this manual, the operations using the
remote control is nminly explained; however, you can use
the buttons arrd controls on the main unit if they have the
same (or similar) name arrd nmrks.
• Some related tips and notes are explained later in the
sections "Learning More about This System" and
"Troubleshooting," but not in the same section
explaining the operations ( _ indicates that the
content has some informations). If you want to know more
about tire functions, or if you have a doubt about the
function, go to these sections and you will find your answer
there.
Indicates that you press the button
briefly.
Indicates that you press the button
briefly and repeatedly until an
option you want is selected.
Indicates that you press one of the
buttons.
Indicates that you press and hold tile
button for a specified period.
• The number inside the arrow
irrdicates the period of press (in this
example, 2 seconds).
• If no number is inside the arrow,
press arrd hold until the entire
procedure is complete or until you
get a result you want.
Indicates ttmt you turn tile control
toward the specified direction(s).
Indicates flint this operation is only
possible using tile remote control.
Indicates flint this operation is only
possible using the buttons atrd controls on
tile main unit.
2
To Next Page
Loading...
