1-10 (No.22041)
2.1.6 Removing the T.flux board
(See Fig.17, 18)
• Prior to performing the following procedure, remove the metal
cover and the CD changer mechanism assembly .
(1) Disconnect the card wire from connector CN102 on the
T.flux board.
(2) Remove the two plastic rivets attaching the T.flux board.
(3) Remove the T.flux board from the bracket which is located
on the inner bar. (two joints d)
Fig.17
Fig.18
T.flux board
Front panel assembly
Inner ba
Plastic rivet
Plastic rivet
d
T.flux board
CN102
To Next Page
Loading...
