(No.22041)1-13
2.1.10 Removing the power transformer assembly
(See Fig.28,29)
• Prior to performing the following procedure, remove the metal
cover, the CD changer mechanism assembly, the rear panel,
the main board and the bridge board / regulator board.
(1) Remove the screw O attaching the primary board.
(2) Disconnect the wire from connector CN231 and CN232 on
the primary board.
(3) Remove the four screws P attaching the power transform-
er assembly.
(4) Detach the cord stopper from the base chassis upward.
REFERENCE:
When disconnecting the power cord from connector CN250 on
the primary board, remove the fixing band.
Fig.28
Fig.29
Primary board
Power transformer assembly
O
Primary board
CN231,CN232
CN250
Cord stopper
Band
Power transformer
assembly
P P
To Next Page
Loading...
