28 ENGLISH
Category
Menu item Selectable setting, [ Initial: Underlined ]
Color Setup
Ring Color *
2
• On
• Off
: When a call comes in, the display will flash in blue.
• The display will change to the original color
when the call is answered or the incoming call
stops.
When the unit receives a text message, the
display only illuminate in blue.
: Cancels.
Audio
Fad/Bal *
3,
*
4
Fader/balance
R6 – F6, [ 0 ]
L6 – R6, [ 0 ]
: Fad (fader): Press
5
/
∞
to adjust the front and
rear speaker output balance.
: Bal (balance): Press
4
/
¢
to adjust
the left and right speaker output balance.
Loud
Loudness
•
Loud 1/2/3
• Off
: Boost low and high frequencies to produce a
well-balanced sound at a low volume level.
: Cancels.
Volume Adjust Level –5 —
Level +5,
[ Level 0 ]
: Preset the volume adjustment level of each source
(except FM), compared to the FM volume level.
The volume level will automatically increase or
decrease when you change the source.
• Before making an adjustment, select the source
you want to adjust.
• “FIX” appears on the display if “FM” is selected as
the source.
Subwoofer • LPF
• Level
• Phase
: Turn the control dial to select the cutoff
frequency to the subwoofer.
Off: All signals are sent to the subwoofer.
LPF 55Hz/LPF 85Hz/LPF 120Hz: Frequencies
higher than 55 Hz/85 Hz/120 Hz are cut off.
: Turn the control dial to adjust the subwoofer
output level. Level 00 to Level 08 [ Level 04 ]
: Turn the control dial to select the subwoofer
phase. 0deg (normal) or 180deg (reverse)
HPF
High Pass Filter
Select the cutoff frequency to the front/rear speakers. Set this to
match the LPF settings.
• 62Hz/95Hz/
135Hz
• Off
: Frequencies lower than 62 Hz/95 Hz/135 Hz are
cut off.
: All signals are sent to the front/rear speakers.
*
2
Displayed only when USB Bluetooth adapter, KS-UBT1 is connected.
*
3
If you are using a two-speaker system, set the fader level to <0>.
*
4
This adjustment will not affect the subwoofer output.
EN28-37_KD-R811_003A_f.indd 28EN28-37_KD-R811_003A_f.indd 28 1/20/10 3:07:35 PM1/20/10 3:07:35 PM
To Next Page
Loading...
Need help?
General
