4
When connecting the external components, refer also to the manuals supplied for the components and adapters.
CAUTION:
Before connecting the external components, make sure that the unit is turned off.
You can connect the following JVC components to the CD changer jack.
JVC component Model name
CD changer (CD-CH) CH-X1500, etc.
You can also connect the following components through the various JVC adapters.
• Connection cords may need to be purchased separately.
Component Adapter Model name
Bluetooth device Bluetooth adapter KS-BTA200
iPod Interface adapter for iPod KS-PD100
Portable audio player with line output jacks Line input adapter KS-U57
Portable audio player with 3.5 mm stereo mini jack AUX input adapter KS-U58
When connecting more than one component (maximum: two), it is recommended that you connect the components in series as explained below.
*
3
To use these components, set the external input setting correctly (see page 39 of the INSTRUCTIONS).
Connecting the external components
F
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
To disconnect the connector
Hold the connector tightly ( 1 ), then pull it out ( 2 ).
CD changer jack
External component
You can also connect an external component to the LINE IN plugs of the unit using a signal cord (not supplied).
Signal cord (not supplied for this unit)
A KS-BTA200
B *
3
CD-CH / KS-PD100 / KS-U57 / KS-U58
When connecting two components in series
Install2_KD-DV5506_008A_f.indd 4Install2_KD-DV5506_008A_f.indd 4 2/25/09 2:39:38 PM2/25/09 2:39:38 PM
To Previous Page
Loading...
Need help?
General
