14
ENGLISH
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
BLUETOOTH®
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
Adjust the
microphone angle
Secure using cord clamps
(not supplied) if necessary.
Microphone input jack
Microphone (supplied)
Rear panel
Pair and connect a Bluetooth device for the first time
1
Press source button to turn on the unit.
2 Search and select “KD-R9 BT”/“KD-R8 BT”/“KD-R7 BT” on the Bluetooth device.
“BTPAIRING” flashes on the display.
• For some Bluetooth devices, you may need to enter the Personal Identification Number
(PIN) code immediately after searching.
3 Perform (A) or (B) depending on what appears on the display.
For some Bluetooth devices, pairing sequence may vary from the steps described below.
(A)
KD-R991BT
/
KD-R891BT
: “[Device Name]” “XXXXXX” “ENTER–YES” “BACK–NO”
KD-R792BT
: “[Device Name]” “XXXXXX” “VOL–YES” “BACK–NO”
“XXXXXX” is a 6-digit passkey randomly generated during each pairing.
Ensure that the passkeys appear on the unit and Bluetooth device are the same.
Press the following operation to confirm the passkey.
KD-R991BT
/
KD-R891BT
:
KD-R792BT
: volume knob
Operate the Bluetooth device to confirm the passkey.
(B)
KD-R991BT
/
KD-R891BT
: “[Device Name]” “ENTER–YES” “BACK–NO”
KD-R792BT
: “[Device Name]” “VOL–YES” “BACK–NO”
Press the following to start pairing.
KD-R991BT
/
KD-R891BT
:
KD-R792BT
: volume knob
• If “PAIRING” “PIN 0000” scrolls on the display, enter the PIN code “0000” into the
Bluetooth device.
You can change to a desired PIN code before pairing.
( 19)
• If only “PAIRING” appears, operate the Bluetooth device to confirm pairing.
“PAIRING COMPLETED” appears when pairing is completed and “ ” will light up when the
Bluetooth connection is established.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered in the unit even if
you reset the unit. To delete the paired device,
19
,
[DEVICE DELETE]
.
JS_JVC_KD_R991BT_M_EN_2.indd 14JS_JVC_KD_R991BT_M_EN_2.indd 14 7/24/2017 10:17:06 AM7/24/2017 10:17:06 AM
To Next Page
Loading...
