Prior to performing the following procedure, remove
the CD mechanism control board.
Remove the two springs g attaching the CD mechanism
ass’y and the front bracket.
Remove the two screws C and the front bracket
while pulling the flame outward.
Remove the belt and the screw D from the loading
motor.
*
1.
2.
3.
Removing the loading motor
(See Fig.3 to 5)
Prior to performing the following procedure, remove
the CD mechanism control PWB and the front
bracket (loading motor).
Remove the three screws A and the damper
bracket.
Raise the both sides fix arms and move the fix plates
in the direction of the arrow to place the four shafts A
as shown in Fig.8 and 9.
Remove the CD mechanism ass’y and the two
springs f attaching the flame.
Remove the two screws E and both sides rear
damper brackets from the dampers. Detach the CD
*
1.
2.
3.
4.
Removing the CD mechanism ass’y
(See Fig.1, 6 to 9)
The CD mechanism ass’y can be
removed if only the rear damper
bracket on the left side is removed.
ATTENTION:
Fig.5
Fig.6
Fig.7
Fig.8
Fig.9
Rear damper bracket
Fix arm (R)
Damper
y
D
A
A
Loading motor
Belt
Damper bracket
CD mechanism ass’y
Flame
f
f
A
A
Fix plate (L)
h
h
Rear damper bracket
Fix arm (L)
Damper
E
Fix plate(R)
E
l
h
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com
“无奇不有”电路图网 http://www.xiaoyu163.com
To Next Page
Loading...
