JVC KD-S79BT

Menu item
Selectable setting (Initial: [XX])
USB *8 DRIVECHANGE: Selects to change the drive when a device with multiple
drives is connected to the USB input terminal (front/rear).
IPOD SWITCH *9
(iPod/iPhone control)
[HEAD MODE]/IPOD MODE/APP MODE:
For settings, ' page 11.
AUDIOBOOKS *9 NORMAL/FASTER/SLOWER: Selects the playback speed of the
Audiobooks sound file in your iPod/iPhone.
Initial selection depends on your iPod/iPhone setting.
BLUETOOTH *10
PHONE *11 CONNECT/DISCONNECT: Connects or disconnects the Bluetooth phone/
audio device. (' page 15)
AUDIO
APPLICATION CONNECT/DISCONNECT: Connects or disconnects the application in the
smart phone. (' page 16)
BT AUDIO SW *12 Switches between “BT AUDIO” and “BT PANDORA”.
DELETE PAIR
For settings, ' page 16.
P. BOOK WAIT Copies up to 400 numbers from the phonebook memory of a connected
phone to the unit via OPP.
SET PINCODE Changes the PIN code (1 to 6-digits). (Default PIN code: 0000)
Turn the control dial to select a number, press  /  to move to the entry
position. After entering the PIN code, press the control dial to confirm.
AUTO CNNCT [ON]: Establishes connection automatically with the Bluetooth device when
the unit is turned on.
OFF: Cancels.
INITIALIZE YES: Initializes all the Bluetooth settings (including stored pairing,
phonebook, and etc.).
[NO]: Cancels.
INFORMATION PH CNNT DEV/AU CNNT DEV/APP CNT DEV *13: Displays connected
phone/audio/application device name.
MY BT NAME: Displays the unit name (JVC Unit).
MY ADDRESS: Shows address of USB Bluetooth Adapter.
SRC SELECT
AM *14 [ON]/OFF: Enables or disables “AM” in source selection.
EXT IN *14 EXT ON/[EXT OFF]: Enables or disables “EXT IN” in source selection.
AUX IN *14 [AUX ON]/AUX OFF: Enables or disables “AUX IN” in source selection.
BT AUDIO *15 [BT AU ON]/BT AU OFF: Enables or disables “BT AUDIO” in source
selection.
SOFT VER Displays the firmware version of the unit.
*8 Displayed only when the source is “USB FRONT/USB REAR”.
*9 Displayed only when the source is “IPOD-FRONT/IPOD-REAR”.
*10 If the USB Bluetooth Adapter is not connected to the unit, “PLEASE CNNT BT ADAPTER” scrolls
on the display.
*11 <CONNECT> will not be displayed if two Bluetooth phones are connected at the same time.
*12 Displayed only when the source is “BT FRONT/BT REAR”.
*13 Displayed only when a Bluetooth phone/audio player/application is connected.
*14
Displayed only when the unit is in any source other than the corresponding source “AM/EXT IN/AUX IN”.
*15 Displayed only when the USB Bluetooth Adapter (KS-UBT1) is attached and current source is
not “BT FRONT/ BT REAR”.
Menu operations
ENGLISHޓ|
25
2012/5/24ޓ9:57:16KD-S79BT_J_EN