JVC KD-SV3204 - Control Panel Overview; Control Panel Parts Identification; Display Window Indicators Explained

AV1-IN
AV2-INPUT
D
4
Other external component
CAUTION
Before connecting the external components, make sure that the unit is turned off.
Connecting the external components
JVC CD changer
External component
3.5 mm stereo mini plug
*
8
AUX Input Adapter KS-U58 (not supplied for this
unit)
• Set “EXT IN” for the external input setting (See page 16 of the INSTRUCTIONS.)
• Set “CHANGER” for the external input setting (See page 16 of the INSTRUCTIONS.)
*
5
iPod is a trademark of Apple
Computer, Inc., registered in the
U.S. and other countries.
CD changer, Apple iPod®, or JVC D. player
F
E
CD changer
jack
External component
Connecting the external amplifier
You can connect an amplifier to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
Rear speakers
JVC Amplifier
Remote lead Y-connector (not supplied for this unit)
Remote lead (Blue with white stripe)
To the remote lead of other equipment or automatic antenna if any
Front speakers
*
3
Firmly attach the ground wire to the metallic body or to
the chassis of the car—to the place uncoated with paint (if
coated with paint, remove the paint before attaching the
wire). Failure to do so may cause damage to the unit.
Connecting the monitor
KV-MR9010
9-INCH WIDESCREEN MONITOR
(not supplied)
Apple iPod
(separately purchased)
JVC D. player
(separately purchased)
CD changer jack
*
4
Signal cord (not supplied for this unit)
You can connect these components as illustrated below. The iPod*
5
or D. player can be connected using an interface adapter (not supplied)—KS-PD100 (for iPod) or KS-PD500 (for D. player).
Video cord (not supplied)
or
Rear side
Or
VIDEO OUT
External component
*
7
Line Input Adapter KS-U57 (not supplied for
this unit)
*
6
Connecting cord supplied for
your CD changer
Before connecting the monitor, make sure the unit is turned off.
Instal3-4_SV3204_002A_f.indd 5Instal3-4_SV3204_002A_f.indd 5 2/7/06 11:35:21 AM2/7/06 11:35:21 AM