JVC KD-X441DBT

ENGLISH
20
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
AUDIO SETTINGS
SPK/PRE  OUT (Not applicable when 3-way crossover is selected.)
Depending on the speaker connection method, select the appropriate
setting to get the desired output. (
Speaker output settings )
SPEAKER SIZE
Depending on the crossover type you have selected ( [X ' OVER TYPE] ),
2-way crossover or 3-way crossover setting items will be shown.
(
21 , Crossover settings )
By default, 2-way crossover type is selected.
X ' OVER
DTA SETTINGS
For settings, 22 , Digital Time Alignment settings .
CAR SETTINGS
X ' OVER TYPE Caution
: Adjust the volume before changing the [X ' OVER TYPE] to
avoid the sudden increase or decrease of the output level.
2-WAY (Displayed only when [3-WAY] is selected)
YES :Selects two way crossover type.; NO :Cancels.
3-WAY (Displayed only when [2-WAY] is selected)
YES :Selects three way crossover type.; NO :Cancels.
SOUND EFFECT
SPACE ENHANCE
(Not applicable for FM/AM source and DAB source.)
SMALL/MEDIUM/LARGE : Virtually enhances the sound space.;
OFF :Cancels.
SND RESPONSE LEVEL1 / LEVEL2 / LEVEL3 : Virtually makes the sound more realistic.;
OFF :Cancels.
SOUND LIFT LOW / MIDDLE / HIGH : Virtually adjust the sound position heard from the
speakers.;
OFF :Cancels.
VOL LINK EQ ON :Boosts the frequency to reduce the noise heard from outside the car
or running noise of the tyres.;
OFF :Cancels.
K2 TECHNOLOGY (Not applicable for FM/AM source, DAB source and AUX source.)
ON :Improve the sound quality of compressed music.; OFF :Cancels.
Speaker output settings [SPK/PRE OUT]
(Applicable only if [X ' OVER TYPE] is set to [2-WAY])
Select the output setting for the speakers [SPK/PRE OUT] , based on the
speaker connection method.
Connection via lineout terminals
For connections through an external amplifier. ( 31)
Setting on
[SPK/PRE OUT]
Audio signal through lineout terminal
FRONT REAR/SW
REAR/REAR Front speakers output Rear speakers output
REAR/SUB.W (default) Front speakers output Subwoofer output
SUB.W/SUB.W Front speakers output Subwoofer output
Connection via speaker leads
For connections without using an external amplifier. However, with this
settings you can also enjoy the subwoofer output.
( 31)
Setting on
[SPK/PRE OUT]
Audio signal through rear speaker lead
L (left) R (right)
REAR/REAR Rear speakers output Rear speakers output
REAR/SUB.W Rear speakers output Rear speakers output
SUB.W/SUB.W Subwoofer output (Mute)
If [SUB.W/SUB.W] is selected:
–
[120HZ] is selected in [SUBWOOFER LPF] and [THROUGH] is not available.
–
[POSITION R02] is selected in [FADER] and selectable range is [POSITION
R15]
to [POSITION 00] .
JS_JVC_KD-X441DBT_E_EN_3.indd 20JS_JVC_KD-X441DBT_E_EN_3.indd 20 11/24/2016 4:18:39 PM11/24/2016 4:18:39 PM