JVC KW-V11 - Using the Bluetooth Mobile Phone

ENGLISH 25
BLUETOOTHBLUETOOTH
R Connecting a registered Bluetooth
device
1 Display the <Bluetooth Setup> screen.
(Page24)
2
3 Select the device you want to connect
(1), then select what you want to use the
device for (2).
[ TEL (HFP)]: for mobile phone
[Audio (A2DP)]: for Bluetooth audio player
• Selectable items depend on the device you
are operating.
• If you connect a device while another device
is connected, the device previously connected
is disconnected and the connection for the
newly connected device is established.
• When a Bluetooth mobile phone is connected,
the signal strength and battery level are
displayed when the information is acquired
from the device.
To disconnect
Select [TEL (HFP)] or [Audio (A2DP)] to disconnect
the Bluetooth device being used for that function
on the <Paired Device List> screen (see the left
column).
R Deleting a registered Bluetooth device
1 Display the <Bluetooth Setup> screen.
(Page24)
2
3 Select a device to delete (1), then delete
the registration (2).
A confirmation message appears. Press [Yes].
Using the Bluetooth mobile phone
R Receiving a call
When a call comes in...
• Call information is displayed if acquired.
• Phone operation is not available while the
picture from the rear view camera is displayed.
(Page21 )
To reject a call
When <Auto Response> is set to [ON] (Page30)
The unit answers the incoming call automatically.
R Ending a call
While talking...
KW-VEntryU.indb25KW-VEntryU.indb25 2014/09/1019:502014/09/1019:50