JVC KW-V230BT - SETTINGS; Sound adjustment; Setting the crossover network mode

62
SETTINGSSETTINGS
Sound adjustment
❏ Using the sound equalization
• The adjustments are memorized for each source
until you adjust the sound again. If the source is
a disc, the adjustments are stored for each of the
following categories.
– DVD/VCD
–CD
– DivX*/MPEG1/MPEG2/MP3/WMA/WAV/AAC/
FLAC
• You cannot adjust the sound when the unit is in
standby.
Selecting a preset sound mode
1 Display the <Settings> screen.
On the Home screen:
KW-V330BT KW-V430BT
KW-V630BT
KW-V230BT
2 Display the <Equalizer> screen.
3 Select a sound mode.
• You can also display the <Equalizer> screen as
follows:
– For KW-V230BT : Press [ ] on the source
control screen.
– For KW-V330BT /KW-V430BT /KW-V630BT :
Select [ ] on the pop-up short-cut menu
(Page12).
* Only for KW-V230BT/KW-V330BT Region 4/KW-V630BT.
Storing your own adjustments—Adjusting the
sound precisely
1 Select a sound mode. (See the left column.)
2 Select a band and adjust the level of the
selected band.
• You can adjust the level by dragging the slider
or using [J]/[K].
• Repeat this step to adjust the level of other
bands.
The adjustments are stored and <User> is
activated.
3 Adjust the sound.
<Q factor> Adjusts the width of the
frequency.
<Bass EXT> Activates ([ON])/deactivates
([OFF]) bass.
<SW LEVEL> Adjusts the subwoofer level.*
• To apply the adjusted equalizer to all playback
sources, press [ALL SRC], then press [OK] to
confirm.
• To clear the adjustment, press [EQ INIT].
* Not adjustable when <None> is selected for subwoofer on the
<Speaker Select> screen. (Page63)
❏ Setting the crossover network mode
Select the appropriate crossover network mode
according to the speaker system (2-way speaker
system or 3-way speaker system).
1 Turn off the AV source. (Page7)
2 Display the <X’over Network> screen.
Press the following buttons at the same time:
• For KW-V230BT : and EQ
• For KW-V330BT :
and
• For KW-V430BT /KW-V630BT : FNC and
volume–
3 Select the crossover network mode.
[2way] Select this when connecting speakers
in a 2-way system (front/rear).
[3way] Select this when connecting speakers
in a 3-way system (tweeter/mid
range/woofer).
A confirmation message appears. Press [Yes].
2017KW-VEntryK.indb622017KW-VEntryK.indb62 2016/12/0915:112016/12/0915:11