JVC KW-V230BT - CONNECTION;INSTALLATION; Connecting wires to terminals for KW-V230 BT;KW-V330 BT;KW-V430 BT

ENGLISH 79
See page82.
See page83.
See page82.*
1
See page82.
USB terminal (1.0 m): See page81.*
3
10 A fuse
Ignition key switch
Fuse box
Battery
Connect to the vehicle’s reverse lamp harness
when using the optional rear view camera.
Connect to the vehicle’s parking
brake detection switch harness.
• For best safety, be sure to connect
the parking sensor.
To the power control terminal when using the optional power amplifier.
(Or)
To the control terminal of the motor antenna or to the power terminal for the booster
amplifier of film-type antenna.
To the OE remote adapter (not supplied) which is compatible with your car.
To car light control switch.
To car chassis
Purple with white stripe (Reverse sensor wire)
Light green (Parking sensor wire)
1
White ª / White with black stripe · : To front/mid range speaker (left)*
4
Gray ª / Gray with black stripe · : Tofront/mid range speaker (right)*
4
Green ª / Green with black stripe · : To rear/tweeter speaker (left)*
4
Purple ª / Purple with black stripe · : To rear/tweeter speaker (right)*
4
Blue with white stripe (Power control wire/Antenna control wire) (12 V 350 mA)
Light blue with yellow stripe (Steering remote control wire)
Orange with white stripe (Dimmer control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
*
5
*
5
*
1
Only for KW-V330BT Region 1/KW-V430BT.
*
2
Only for KW-V230BT/KW-V330BT Region 4.
*
3
Only for KW-V330BT/KW-V430BT.
*
4
For 3 way speaker system connection, see also page83.
*
5
If no connections are made, do not let the cable come out
from the tab.
Connect the antenna cord
to the antenna terminal.
*
2
*
1
3
CONNECTION/INSTALLATIONCONNECTION/INSTALLATION
Connection
❏ Connecting wires to terminals for KW-V230BT/KW-V330BT/KW-V430BT
2017KW-VEntryK.indb792017KW-VEntryK.indb79 2016/12/0915:112016/12/0915:11