26
BLUETOOTHBLUETOOTH
 R Adjusting the volume of calls/earpiece/
microphone
While talking...
•   You can adjust the volume level between –20 to 
+8 (initial: 0). 
•  Use the monitor panel to adjust the call/earpiece 
volume. (Page7  )
 R Switching between handsfree mode 
and phone mode
While talking...
 Each time you press the button, the talking method 
is switched (   : handsfree mode /    : phone 
mode).
 R  Notification when SMS is received
If the mobile phone is compatible with SMS (Short 
Message Service), the unit tells you a message has 
been received when <SMS Notify> is set to [ON]. 
(Page30)
•  To read a received message, operate the mobile 
phone after stopping the car in a safe place.
 – You cannot read, edit, or send a message 
through the unit.
•  For some mobile phones, the notification message 
may not be shown even if the SMS function is 
supported.
 R  Reducing noise/adjusting the echo 
cancel level
While talking...
Activate the noise reduction/echo cancel function 
(1), then adjust the level (2).
 
•  To adjust the echo volume (between 1 to 10, 
initial: 4): Adjust <EC LEVEL>.
•  To adjust the noise reduction volume (between 
−5 to −20, initial: −7) : Adjust <NR LEVEL>.
 R  Making a call
 1  Display the <Hands Free> screen.
On the Home  screen:
  
•   You can also display the <Hands Free> screen 
by pressing   /    on the monitor panel.
2  Select a method to make a call.
132 4
1
From the phone book/call lists
2
Direct number entry
3
Voice dialing
4
Preset list
•  To preset, see page28.
KW-VEntryU.indb26KW-VEntryU.indb26 2014/09/1019:502014/09/1019:50