JVC KW-V950BW - Page 57

Other External Components
57English
■ [Rear Camera Interruption]
[ON] (Default): Displays the picture from the
rear view camera when you shift the gear
to the reverse (R) position.
[OFF]: Select this when no camera is
connected.
■ [Parking Guidelines]
You can display parking guidelines to enable
easier parking when you shift the gear to the
reverse (R) position.
Default is “ON”.
■ [Guidelines SETUP]
If you select [ON] for [Parking Guidelines],
you can adjust the parking guidelines. See To
adjust the parking guidelines (P.58).
■ [[Front Camera Interruption]*
1
[10 sec]/[15 sec] (Default)/[20 sec]: The front
camera screen is displayed when return
the gear from the reverse (R) position.
[OFF]: Cancel.
*
1
Only when FRONT VIEW CAMERA is set to
“Front” on the Camera Assignment Settings
screen.
Ñ To set up the camera
assignment settings
1
Touch [Camera Assignment Settings] on
the Camera screen. (P.56)
2
Set each item as follows.
■ [FRONT VIEW CAMERA]
Set the camera assignment from view
camera connected to Front view camera
input terminal.
■ AV-IN
Set the camera assignment from view
camera connected to AV-IN input terminal.
For Front view camera input terminal:
1
Touch [FRONT VIEW CAMERA].
 Displays the picture from view camera
connected to Front view camera input
terminal.
2
Select the view camera to set up.
2
4 5
31
1
[Picture from view camera]
Displays the picture from view camera
connected to Front view camera input
terminal. (P.97)
2
[Front]
3
[Right]
4
[Left]
5
[None]
3
Touch [Enter].
For AV-IN input terminal:
1
Touch [AV-IN].
 Displays the picture from view camera
connected to AV-IN input terminal.
2
Select the view camera to set up.
2
4 5
31
1
[Picture from view camera]
Displays the picture from view camera
connected to AV-IN input terminal. (P.97)
2
[Front]
3
[Right]
4
[Left]