4
How to attach the stand
NOTE:
• Unplug the AC cord from the AC INPUT terminal.
• Before beginning this process, assure that TV is laid on a clean, safe, and cushioned space to avoid any
damage to the unit.
• Do not touch or press the TV-screen, glass might break under pressure.
• Be sure to follow the instructions. Insufficient tightening or incorrect installation of the stand will not sup-
port your unit correctly, and could result in damage or injury from tip-over.
1) Place the TV on its front onto a table.
2) Align the stand’s bottom-plate (supplied) as seen here.
It will fit in only one direction.
3) Hold the unit and attach the stand and frame stand slowly. Finally secure the bottom-plate with screws
(included).
Dismantling the base
For wall mounting, the base must be dismantled. To do this, remove screws (J, see page 8) from the back.
Take off the stand and frame stand entirely.
NOTE:
To detach the stand, perform these steps in reverse order.•
LT-32A4 LT-40Z40
3IZ0101A_EN.indd 43IZ0101A_EN.indd 4 9/21/11 5:30:05 PM9/21/11 5:30:05 PM
To Next Page
Loading...
Need help?
General
