EasyManua.ls Logo

JVC LT-32C672 - Preparation

JVC LT-32C672
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
2 Preparation
Unpacking the TV
Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to local regulations.
The following items are included:
Thank you for purchasing your new JVC TV.
Your new TV has many features and incorporates the latest technology to enhance your viewing
experience. We recommend that you spend some time reading this instruction manual so that you fully
understand these features. You will also find some hints and tips to help you resolve any issues.
Read all the safety instructions carefully before use and keep this instruction manual for future reference.
Chapter
2
Remote Control /
AAA Batteries x 2
Stand screws x6
Instruction Manual Quick Start Guide
Instruction Manual
32" LED Smart HD TV
LT-32C672
GB
• Keep theprotectivebagonyourTVuntilyouhaveattachedthestandandpositionedtheTV.
• The LCDdisplayisveryfragile,andmustbeprotectedatall timeswheninstallingandremovingthebasestand.Besurethatnohardorsharpobject,
oranythingthatcouldscratchordamagetheLCDdisplay,comesinto contactwithit.DONOTexertpressureonthefrontof theTVatanytimebecause
thescreencouldcrack.
PleaseinspectyourTVfordamageafterunpacking.Ifyoudonoticeany damagepleaseconsultyourdealer.
Removeallpackagingfromtheunit.Retainthepackaging.Ifyoudisposeofitpleasedosoaccordingtoanylocalregulations.
 TV
 TVStand

 RemoteControl/
AAABatteriesx2
 Screwsx6
 InstructionManual
 QuickStartGuide
Unpacking
1
1. Slideopenthebatterycompartmentonthebackoftheremotecontrol.
Operating Your Remote Control
2
Thank youforpurchasingyournewJVCTV.
YournewTVincorporatesthelatesttechnologytoenhance
yourviewingexperience.Wewouldsuggestthatyouallow
about20minsforinitialsetup.
Pleasefollowthisguideforasuccessfulrsttimeinstallation.
Thelatesteco-friendlypower-savingtechnologywill
switchotheTVifitisleftonandidlefor4hours.Please
referto“AutoStandby”underthe“TimeSettings”section
oftheinstructionmanualformoredetail.
Quick Start Guide
32" LED Smart HD TV
LT-32C672
2. InserttwoAAAsizebatteries.Makesuretomatchthe(+)and(-)
endsofthebatterieswiththe(+)and(-)endsindicatedinthebattery
compartment.
3. Slidethebatterycompartmentcoverbackintoplace.Makesureitclicks
intoplace.
• Do notconnecttheTVtothemainssupplyuntilyouhavecompletedalltheconnections.
• Al waysdisconnecttheTVfromthemainssocketwhennotinuseforalongperiodoftime.
• The
buttonontheremotecontrolisonlyusedforswitchingtheTVintostandby,itdoesnot disconnecttheTVfromthemainspower.
Tocompletelydisconnectthemainspower,pleaseremovethemainsplug fromthemainssocket.
1. ConnectoneendoftheRFcoaxialcabletotheaerialsocketonthewall
andtheotherendofthecabletotheANTsocketonthebackofyourTV.
2. PlugtheTVintoamainssocketandswitchonatthemains.
3. Instandbymode,pressthe
buttonontheremotecontroltoturnthe
TVon.TheLEDindicatorwillashforafewsecondsthentheTVwill
switchon.
Connecting the Aerial and Turning on the TV
4
SCART
SPDIF
Optic.OUT
VGA
ANT.
HDMI 1
(ARC)
HDMI 2
LAN
SCART
SPDIF
Optic.OUT
VGA
ANT.
HDMI 1
(ARC)
HDMI 2
LAN
RF coaxial cable
(not included)
Optional
Ifyouwanttoconnecttotheinternetviaa wiredconnection
thenconnectyourethernetcabletotheLANsocket.
Installing the TV Stand
3
Slide under
the lip
SCART
SPDIF
Optic.OUT
VGA
ANT.
HDMI 1
(ARC)
HDMI 2
LAN
Table
Cushioned
material
TVstand(supplied)
Fitting the Stand to the TV
3. EnsuretheTVisswitchedoandnotconnectedtothemainspowersupply.
4. LaytheTVdownonaatsurfaceideallyontheedgeofatablesothebaseoftheTVslightly
overhangstheedgeofthetable,withthebacksidefacingup.Pleasemakesureasoftcushioned
material(suchasadrybathtowelorthickpieceoffoam)isplacedbeneaththescreen.
5. Slidethestandunderthelip,theneckwilltsnuglyoverthescrewholes.
ThenscrewthestandtotheTVusingthe4screwssupplied.
Fitting the Stand Neck and Base Together
1. Fittheneckontothebase.
2. Using2ofthesuppliedscrews,screwthenecktothebase.
Protective
Bag
SUBT.LANG.
TXT
MENU
Q. MENU
EXIT
BACK
OK
6
MNO
9
WXYZ
0
TV
7
PQRS
8
TUV
4
GHI
5
JKL
.,/@
2
ABC
3
DEF
V
P
EPG
TV
TV Stand (base) TV Stand (neck)
LT-32C672_IB.indd 10 26/07/2017 08:13

Table of Contents