O
PERATING DVD
38
EN
Stereo Sound Mode
CD VCD
This unit allows you to select a sound mode during CD playback.
During playback, press [AUDIO] repeatedly until the
desired sound mode appears.
STEREO
Each time you press [AUDIO], the sound mode
changes as example below.
STEREO (stereo sound with left and
right channels)
L-ch (left channel sound only)
R-ch (right channel sound only)
Note:
Virtual surround cannot be changed when the sound mode
is set to either “L-ch” or “R-ch”.
•
Virtual Surround
DVD CD VCD MP3
You can enjoy virtual surround on your existing 2 channel stereo system.
1
During playback, press [MODE] repeatedly until “ ”
appears.
OFF
2
Press [ENTER] to select the sound level.
1
1 : Natural effect.
2 : Emphasized effect.
OFF : No effects (original sound).
3
Press [BACK/RETURN] to exit.
Note:
The setting will be kept even if the unit is turned off.
For audio CD and video CD, virtual surround will not be
effective if the sound mode is set to something other than
“STEREO”.
Refer to “Stereo Sound Mode”.
Turn down the level or select “OFF” if the sound is distorted.
•
•
•
•
Marker Setup
DVD CD
VCD
w/o PBC
This feature allows you to assign a specific point on a disc to be called back later.
To set a marker
1
During playback, press [SEARCH MODE] repeatedly
until “
” appears.
e.g.) DVD
2
Use [Cursor s / B] to select an available marker within
30 seconds.
3
When the playback reaches the point at which you
want to set a marker, press [ENTER].
Marker is now set.
4
Press [BACK/RETURN] to exit.
To return to the marker later
1
To select a desired marker, repeat steps 1-2 in “To set a
marker”.
e.g.) DVD
2
Press [ENTER] at the desired marker to restart playback
from the specific point which you set.
Note:
Marker search menu will disappear in about 30 seconds
when there is no input.
You can mark up to 10 points.
To clear a marker, select the marker to be cleared at step 2
in the section “To set a marker” or “To return to the marker
later”, and then press [CLEAR].
Ejecting the disc or turning off the power will erase all
markers.
Selecting “ ” at step 2 in the section “To set a marker” or
“To return to the marker later” will also erase all markers.
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General
