JVC LT-40C750 - Installing; Removing the Base Stand; Fitting the Stand to the TV

2
Preparation
9
Installing / Removing the Base Stand
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that
no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert
pressure on the front of the TV at any time because the screen could crack.
Fitting the Stand to the TV
1. Ensure the TV is switched off
and not connected to the mains
power supply.
2. Lay the TV down on a flat
surface ideally on the edge of
a table so the base of the TV
slightly overhangs the edge of
the table, with the back side
facing up. Please make sure a
soft cushioned material (such as
a dry bath towel or thick piece
of foam) is placed beneath the
screen.
Slide under
the lip
SCART
SPDIF
Optic.OUT
VGA
ANT.
HDMI 1
(ARC)
HDMI 2 HDMI 3
LAN
Slide under
the lip
SCART
SPDIF
Optic.OUT
VGA
ANT.
HDMI 1
(ARC)
HDMI 2 HDMI 3
LAN
Table
Cushioned
material
3. Slide the stand under the lip,
the neck will fit snugly over the
screw holes. Then screw the
stand to the TV using the
4 screws supplied.