English - 9 -
Inserting the Batteries into the Remote
Remove the screw that secure the battery compartment
cover on the back side of the remote control rst. Lift
the cover gently. Insert two AAA batteries. Make sure
the (+) and (-) signs match (observe correct polarity).
Place the cover back on. Then screw the cover back
on again.
Batteries should not be exposed to excessive heat
such as sunshine, re or the like.
Connect Power
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Antenna/Cable Connection
Connect the “aerial” or “cable TV” plug to the AERIAL
INPUT (ANT) socket located on the back of the TV.
Specications
TV Broadcasting PAL B/G D/K I
Receiving Channels
VHF (BAND I/III) - UHF
(BAND U) - HYPERBAND
Number of Preset
Channels
1000
Channel Indicator On Screen Display
RF Aerial Input 75 Ohm (unbalanced)
Operating Voltage 220-240V AC, 50Hz.
Audio German+Nicam Stereo
Audio Output Power
(WRMS.) (10% THD)
2 x 6 W
Power Consumption 75W
Weight (kg)
with stand without stand
12,50 kg 9,85 kg
TV Dimensions WxHxD
(with stand) (mm)
923 x 588 x 220
TV Dimensions WxHxD
(without stand) (mm)
923 x 544 x 79/98
Operation temperature
and operation
humidity:
0ºC up to 40ºC, 85%
humidity max
To Next Page
Loading...
Need help?
General
