12
Disconnecting the stand
If you disconnect the stand, attach the bottom cover and the screw (supplied) into the hole.
1) Place the TV face down on a soft cloth on a table.
2) Remove the screws from the back of the TV.
3) Pull out the stand from the TV.
4) Cover the hole with the supplied bottom cover and tighten the screw.
Notes:
• To re-install the stand, reverse the procedure from 4) to 1).
• If you fi nd it diffi cult to remove the screws from inset screw wells, use a magnetized
screwdriver.
Package Contents
LCT2518-001A-A.indd 12LCT2518-001A-A.indd 12 1/14/09 8:54:55 AM1/14/09 8:54:55 AM
To Next Page
Loading...
