14
When using the remote control
Point the top of the remote control towards the remote
sensor as directly as possible. If you operate it from a
diagonal position, the operating range (approx. 5 m) may
be shorter.
When placing the main unit vertically (with the DISPLAY MODE
switch set to “V”)
When placing the main unit horizontally (with the DISPLAY
MODE switch set to “H”)
Remote sensor
Remote sensor
Changing the Scanning Mode
INFO
Select the video signal output according to
the type of your TV after connecting the main
unit to the TV.
• Turn on the System before setting the scanning mode.
See page 17.
• There is no need to make this setting when you connect
the TV with a composite video cord.
1 Select DVD/CD as the source.
2 Enter the scanning mode setting.
• Finish the following process while the setting item is
flashing.
Remote
ONLY
Ex.: When the TV is connected to the HDMI
MONITOR OUT terminal
Continued on the next page
EN_NX-T10[UG]_CS2.indb 14EN_NX-T10[UG]_CS2.indb 14 09.12.14 9:53:10 PM09.12.14 9:53:10 PM
To Next Page
Loading...
Need help?
General
