JVC PC-X130 B - Page 12

PC — X130 B/E/G/GI/EN |
¢ To stop a disc temporaril
Press the PLAY/PAUSE tw) button to stop play
temporarily. When pressed a play resumes from
the point where it was paused.
Caution:
® To change discs, press the STOP/CLEAR (Q)
button; check that the disc has stopped rotating
completely before unloading it.
Notes:
® The following indication may be shown when a disc is
aly or scratched, or when the disc is loaded upside
lown.
In such a case, check the dise and insert again after
cleaning the disc or turning it over.
Keep pressing for fast-reverse search
Direct access playback (using the remote control)
@ Pressing any of the track number buttons will start
playing from the beginning of the designated tune,
without your having to press the CD m/it button. (This
function cannot be used during programmed play.)
w/CLEAR
12 (No. 1892}
® Do not use the unit at excessive high or cold
temperatures. The recommended temperature
range is from 5°C (41°F) to 35°C (95°F).
e After playback, unload the disc and close the Disc
holder.
® If mistracking occurs during play, lower the volume.
@ Mistracking may occur if a strong shock is applied to the
unit or if itis used in a place subject to vibrations (i.e. in
a car travelling on a rough road).
Skip playback
@ During playback, it is possible to skip forward to the
beginning of the next tune or back to the beginning of
the tune being played or the previous tune; when the
beginning of the required tune has been located, play
starts automatically.
To listen to the next tune ...
Press the m1 button once to skip to the beginning of the
next tune.
To listen to the previous tune ...
Press the <4 button to skip to the beginning of the tune
being played back and press again to skip to the beginning
of the previous tune.
Search playback (to locate the required position
on the disc)
© The required position can be located using fast-forward
or reverse search while playing a disc.
Ke SEARCH DPI
1 SKIP Keep pressing for fast-forward search
@ Hold down the button; search play starts slowly and
then gradually increases. in speed.
© Since low-volume sound (at about one quarter of the
normal level) can be heard in the search mode, monitor
the sound and release the button when the required
position is located.
@ Press the w/CLEAR buiton to set to the CD mode.
@ if the PLAY button of the deck A or B is pressed,
press the STOP/EJECT (m/4) button to set to the
stop mode.
@ Designate the required tune using the track number
buttons.
@ To designate tune numbers 1 to 10, press the track
number button corresponding to the tune (track)
number.
© To designate tune number 11 or higher, press the
+10 button the required number of times, then the
track number button. (Example: To designate the
25th tune, press the +10 button twice, then press
track number button 5.)
* +10 button:
Each time this button is pressed, the number increases by
10. First press this button to set the 10’s digit, then press
the track number button to set the 1's digit.
® To skip to another tune during play
When the required track number button is pressed, the
display shows the designated track number and play
starts from the beginning of the designated tune.