EN
BATTERY BACKUP
The clock, alarm and preset stations settings can be protected against AC power
failure with the batteries for a short period of time. If no backup batteries are installed
or the power failure is prolonged, you will need to set the clock again.
STANDBY MODE
Place the unit on a at stable surface and plug the power cord into the mains socket.
The unit is in standby mode and “0:00” will ash on the display.
SETTING THE CLOCK
In standby mode, press and hold SET until the display ashes.
• Press repeatedly HR to set the hours.
• Press repeatedly MIN to set the minutes.
• Press SET to confirm.
The hour and minute digits will stop ashing.
NOTE: Press and hold HR and MIN for fast forward.
RADIO OPERATION
Press POWER to turn on the radio.
• The radio frequency (the default FM frequency or the last frequency you tuned) will
briefly appear on the display and then return to clock time.
NOTE:The default FM radio frequency is 87,5 MHz, AM radio frequency is 522 kHz.
• Press repeatedly BAND to select the desired radio band.
• Adjust the volume by repeatedly pressing VOLUME /.
• Repeatedly press TUNING / to tune into the desired station.
• Press and hold TUNING / for auto forward or backward radio station searching.
NOTE: For the best FM reception, extend the FM aerial to its full length. For the best AM reception,
rotate the unit to the position giving best reception.
PRESETTING YOUR FAVOURITE RADIO STATION
Up to 10 FM and 10 AM radio stations can be preset.
• Tune into the station that you wish to preset.
• Press and hold SET for about 2 seconds, “P01” will flash on the display.
• Press SET again to store the station.
• Repeat previous steps to store desired stations.
To listen to preset radio stations, press MEM repeatedly to select the desired radio
station.
To Next Page
Loading...
