JVC RC-QN1 - Page 11

1-18
SOUND
AHB PRO
VOLUME +, -
Turning the Unit On
Press the (/| button.
O/1
or
The POWER ON indicator (green) lights up and the display comes
on.
The Unit comes on ready to continue in the mode it was in when the
power was last turned off.
For example, if the last thing you were doing was listening to a
CD, you are now ready to listen to a CD again. If you wish, you
can change to another source.
Mi if you were listening to the Tuner last, the Tuner comes on play-
ing the station it was last set to.
Note: When power is supplied from the batteries, the (/I. button
on the Remote Control does not work.
Turning the Unit Standby
Press the ©/i button again.
When operating on AC power:
/1
STAMOS AON :
O/I w—o
. |
or 2
” i ~
The STANDBY indicator lights up and the display is blank, except
for the clock display.
MB When in Standby mode, the Unit continues to a small amount of
power (2.8 W) to run the display.
HE To switch off the Unit completely, unplug the AC power cord
from the AC outlet.
When power is supplied from the batteries:
When the Unit is turned off with the ©/| button on the Unit (the
©/| button:on the Remote Control is ineffective), the Standby in-
dicator goes out and the display is blank, except for the clock dis-
play. Further, the backlight for the display goes out.
To switch off the Unit completely, remove the batteries from the
Unit.
POWER. indicator: oS = i
“3
You can adjust the volume level between. 0 and.25 when the Unit is
turned on.
Tum the VOLUME control. on the Unit to the right or left to in-
crease or decrease the volume level.
OR
Es the VOLUME + or — button onthe Remote Control-to increase
crease the volume level:
ving
uy
aaa
errr
anin
Passe
bleliveaae
the
7
VOLUME
control
to
lib
as
a
sudden.
ee
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers.
Be sure to turn down the volume before connecting or putting on
headphones.
You can reinforce the bass sound to maintain rich, full bass at low
volume (you can use this effect only for playback):
To get the effect, press the AHB (Active Hyper Bass) PRO
button.
The “AHB PRO” indicator lights up on the display.
To cancel the effect, press the button again.
The “AHB PRO” indicator goes out.
The System has the following preset sound effects that give you
control over the way your music sounds, so you can tailor it to the
acoustics of your room and the quality of your source. Test. the
sound effects out to hear how each affects the music. Note that the
effects work only during playback.
Sound effects
FLAT: No sound effect.
BEAT: Boosts low and high frequencies. —