JVC RC-QN1 - Page 12

POP: Good for vocal music.
CLEAR: Fora wide, dynamic stereo sound.
To get an effect, press the SOUND button rep
Sound mode you. want appears on the display.
eatedly until the
Each time you press the SOUND button, the display changes as.
shown below:
BEAT =» POP —» CLEAR =—® FLAT
To cancel the effect, press the SOUND button until “FLAT” ap-
pears on the display.
In standby mode, both a digital and an analog are displayed.
In Standby mode, both clocks are displayed on the display.
RC-QN1/QN2/QN3
When the Unit is tured on, the analog clock only is displayed.
To display both clocks while the Unit is turned on, press
the CLOCK/TIMER button on the Unit.
To return to the original display, press the CLOCK/TIMER §
button on the Unit once again. ,
Digital cleck Analog clock
Note: You need to set the clock first in order for it to work: (See
“Setting the Clock” on page 10.)
You can listen to FM and AM stations. Stations can be tuned in.
manually, automatically, or from preset memory storage.
One Touch Radio (AC power only)—
Just press the TUNER BAND button to turn on the Unit and start
playing the station you were last tuned to.
B® Youcan also switch from any other sound source to the radio by
pressing the TUNER BAND button.
Press the TUNER BAND button.
The Band and Frequency you were last tuned to appear on the
display.
Each time you press the button, the band changes as follows:
FM Auto —» FM MONO > AM —>
= Select a station using one of the following
methods.
@ Manual Tuning
Press the k@<¢-or met button repeatedly to move from frequency
to frequency until you find the station you want.
UP DOAWAT = TUNING © UP
. L]
A '
eee a pie 44
‘ ’
‘
OR
JOG ‘dial
Band display, Frequency dd Spay, Preset channel:
Analog clock
Auto Tuning
If you press and hold the -¢-<:or > button for onesecond or
more, the frequency changes down; or up, automatically until a
station is found.
|. Preset Tuning using the Unit (Possible only after pre-
setting stations)
Press the @ PRESET button to select the preset station.
After you have selected the preset number, the band and the fre-
quency are displayed.
¢ Example:Press the @ PRESET button until the preset
number 12 “P- 12” appears.
Pe it om PM OSS
OR
- Preset Tuning using the Remote Control (Possible
oniy after preseiiing stations)
Select the station by entering its preset number on the number
keys.
* Example:For channel 5, press 5. For channel 15, press +10
then 5.
¢« The band and the frequency are displayed.
Turn the antenna for best reception.
¢ For FM broadcast, extend-and turn the telescopic antenna.
1-19