JVC RC-QN1 - Page 13

RC-QN1/QN2/QNS3
1-20
¢ For AM broadcast, turn the. Unit itself.
For FM For AM
You can preset up to 515 FM stations san up to 15, AM stations into
memory using the Remote Control.
Auto Presetting (Using the Unit) —
In each band, you can automatically preset FM-15, AM-15 stations.
Preset numbers will be allocated as stations are found, starting from
the station currently tuned to and moving up the frequency.
4 Select a band (AM or FRM) by pressing the
TUNER BAND button.
ress the a PRESET button for more than
two seconds.
. Repeat steps 1-2 for the other band.
Mi if you want to change any of the auto preset stations, follow the
procedure for Manual Presetting.
CAUTION: If the Unit is unplugs
after approx. five minutes. If this happens, you
will need to preset the stations again.
Manual Presetting seine t the Re-
mote Control)
en Ee stere —
a
eg
—
Number
key(s)
(hold
for.2
seconds,
|
a
dor if a power
failure occurs, the preset stations will be erased
Select a band by pressing the TUNER
BAND button.
ess the << or p> button to tune in a st
Set the preset number by pressing and hold-
ing the number key on the Remote Control.
¢ To preset numbers 1 to 10: Press the number key and hold
down for 2 seconds.
¢ To preset numbers 11 to 15: Press and release the +10 but-
ton, then press the second number key (J to 5) and hold
down for 2 seconds.
When the preset display blinks, the setting is:stored-and:youcan
release the number key. The display returns to the normal band
and frequency display.
Example: Preset number = 12
mm ioc rw 1m
i 1rib&n Fue
The “STEREO” indicator lights up and you'can hear stereo effects.
when a program ts broadcast in stereo:
However if an FM stereo broadcast is hard to receive or noisy. you
can select Monaural mode. Reception improves, but you lose any
stereo effect.
Press the TUNER BAND buiion to select FM
MONO mode.
The “MONO” indicator lights up on the display.
To restore the stereo effect, press the TUNER BAND button
to select FM Auto mode. The “MONO” indicator goes out.
-CD holder
You can use Normal or Repeat Play. Repeat Play can be set to repeat
all or just one of the tracks on. the CD.
One Touch CD Player
ME Just press the CD »/m button.
¢ The power is automatically turned on. Ifa CD is already
inserted, “PLAY” is displayed and the CD will start play-
ing from the first track.
6
~~ CD OPEN
Repeat indicator .
1406 dial
RC-QN3
Only
@
piat.
Playing time, Preset number
To ounl
Track number.
CD indicator/
Analog clock
(Display when using the CD Player)
¢ Ifno CD is inserted, “NO DISC” is displayed on the dis-
play and the CD. ai remains in eee mode.
The CD holder opens.
@ Place a CD, with its label side up.