JVC RC-QN1 - Page 14

fi Gently close the CD holder by hand.
@ Press the CD »/1 button.
The first track of the CD begins playing. —
The CD Player automatically stops when the last track of the CD has
finished playing.
* During playback, the track number being played and the play-
back time elapsed are shown on the display.
To stop playing the CD, press the m button.
The following ie for the CD: is displayed.
Total. number of tracks: :
Playback time elapsed
To pause, press the CD p11.
To cancel pause, press the CD »/m again. Play continues from
the point where it was paused.
Notes:
¢ You can place an 8 cm (3") CD without an adaptor.
¢ If the CD cannot be read correctly (because it is scratched, for
example), “QOOQ000” appears on the display.
* Even if other function is selected during playing the CD, the
last track is memorized.
During playback, press the << or p> button to select the: .
track you want.
The selected track starts playing.
* Press and release the 1 button to go forward one track at a time.
¢ Press and release the «¢ button to go back one track at a time.
(Model RC-QN3)
Tape direction indicators
The Cassette Deck allows you to play and record audio tapes’
Notes:
* The Cassette Deck performs best with normal tapes (metal or
CrO2 tapes are not recommended).
* The use of tapes longer than 120 minutes is not recommended,
since characteristic deterioration may occur and these tapes
easily jam in the pinch-roller and the capstan.
One Touch Play (AC power only) —
Just press the TAPE PLAY button on the Unit. The power is auto-
matically turned on, “TAPE” is displayed, and if a tape is already in
the deck, it will start to play.
RC-QN1/QN2/QN3
During playback, hold down the.+<-< or p>: button.
This. operation will fast forward/backwards the CD so you can {
quickly find a particular passage in the track you are listening to (the |
CD is played slowly for a moment and then the playback speed in-
creases).
Locating a Track directly with the
Using the number keys on the Remote Control allows you can go
directly to the beginning of any track.
During playback, enter the number of the track you want
to listen to using the number-keys.
The selected track starts playing. ;
¢ Example: For.track 5, press 5. For track 15, press +10 then 5.
For track 20, press'+10, then 10. For track 32, press +10 three
times, then 2.
You can repeat one track or all the tracks on a CD.
During, or before playback, press the REPEAT button on
the Remote Control to select the Repeat mode.
The Repeat indicator changes with each press of the button, as
shown below.
Cc > CALL -blank display — (back to the beginning) ©
C : Repeats one-track.
C ALL : Repeats all the tracks.
To exit Repeat mode, press the REPEAT button until the Repeat
indicator on the display goes out.
(Listening to a Tape)
(Model RC-QN2)
7;-~-~ TAPE indicator/Analog clock
(Display when using the Cassette Deck)
The Cassette Deck for RC-QN3 has an auto-reverse function allow-
ing you to continuously play both sides of a tape. The Cassette Deck
on model RC-QN2 piays in one direction only.
ess
the
8/4
STOP/EJECT
button
to
open
— Oe Wii Ene. exposed
side facing unward'a as chown below.
1-21