JVC RC-QN1 - Page 15

RC-QN1/QN2/QN3
+ Forward direction
Close the holder gently until it clicks.
Press the TAPE PLAY button.
¢ On model RC-QN3, both sides of the tape play continu-
ously as follows until you stop the cassette deck.
1. One side (side A for example) is played. The FWD (<1)
direction indicator lights up.
2. When the tape reaches its end, the other side (side B) is
automatically played back. The REV (>) direction
indicator lights up.
3. At.the.tape end, the first side (sideA) is played back...
again, and so on.
* For RC-QN2, the tape is played and then stops when it
reaches the end.
¢ The TAPE indicator turns to the right during Playback and
Recording, even'in Pause mode.
(Model RC-QN3)
t-¢ TAPE PLAY
(For RC-QN3)
Tape direction indicators
Things To Know Before You Start
it may be unlawful to record or oplayeacke deeeaanisd
material without the consent of the copyright owner.
a The correct recording level is automatically set by the ALC
(Automatic Level Control) function, and is not affected by the
VOLUME control on the Unit or by the use of sound effects.
Two-small tabs on the back of the:cassette tape; one for'side.A
and one for side B, can be removed to prevent accidental erasure
or recording.
To record on a cassette with the tabs removed, you must cover
the holes with adhesive tape as shown.
Notes:
¢ Use normal tapes (not metal or CrO2 tapes) for recording.
* At the start and end of cassette tapes, there is leader tape which
cannot be recorded onto.
To change the playback direction, before or during play-
back, press: the DIRECTION button.on. the Unit. (RC-QN3 only)
The tape playback direction changes.
To pause, press the PAUSE button on the Unit. (RC-QN2 only)y.
To cancel pause, press the PAUSE button again. Play continues
from the point where it was paused. (RC-QN2 only)
To stop playing, press the @/& STOP/EJECT button.
To remove the tape, stop the tape, and press the @/4 STOP/
EJECT button again.
Press the <-< (fast-
fast-forward the tape.
Press the p> (rewind) button on the Unit to re-
wind the tape.
¢ The Cassette Deck automatically stops when the tape reaches
its end. (RC-QN?2 only)
¢ For RC-QN3, the tape mins to the left when the <¢¢ button is.
pressed and it runs to the right when the ® button is pressed,
regardless of the indication of the FWD (<1) / REV (>) direction
indicator. The Cassette Deck automatically stops when the tape
reaches its end..
ard) button on the Unit to
¢ The TAPE indicator does not turn during fast-forwarding or
rewinding.
(Recording)
(Model RC-QN2)
2 be |
“@<@ TAPE PLAY
REC indicator
a i! TAPE indicator
: Analog clock
(Display when using the Cassette Deck)
« If arecorded tape you make has excessive noise or static, the
Unit may have been too close to a TV during the recording.
Either turn off the TV or increase the distance between the TV
and the Unit.
slose the holder gently until it clicks.