JVC RC-QN1 - Page 19

RC-QN1/QN2/QN3
page 8.)
Note: If “howling” occurs, keep the microphone away from the
Unit.
gintoa radio ‘station. (S$
exceé
Connect a microphone by plug
the MIC jack on the back of ti
Adjust the volume level, as you sing into
the microphone.
Handle your CDs carefully, and d they w will last a. along th time.
Compact Discs»
¢ Only CDs bearing this mark can be used with
this Unit.
If a tape 1s loose, it may get stretched, cut, or
caught in the cassette. Take up the slack by
inserting a pencil in one of the reels and rotat-
ing in the right direction.
Continued use of irregularly shaped CDs
(heart-shape, octagonal, etc.) can damage the
Unit.
Do not touch the tape surface.
* Remove the CD from its case by holding it at
the edges while pressing the case's center hole
lightly.
¢ Do not touch the shiny surface of the CD, or
bend the CD.
Do not store the.tape:
- In dusty places
- In direct-sunlight or heat
- In damp. areas
- OnaTV or-speaker
¢ Put the CD back in its case after use to prevent - Neara a magnet
warping. sormscrenonnenes mentee ~—e en
. Be careful not to scratch the surface of the CD Cassette [ oe eck
when placing it back in the case. e Ifthe heads, capstan, or pinch-roller in the Cassette Deck
* Avoid exposure to direct sunlight, temperature become dirty, you may experience:
extremes, and moisture. - Loss of sound quality
- Discontinuous sound
- Fading .
- Incomplete erasure
- Difficulty: recording _
¢ Clean the heads, capstans, and pinch-rollers using a cotton
swab moistened with alcohol.
¢ A dirty CD may not play correctly. If a CD is
dirty, wipe it with a soft:cloth in a straight line
from center to edge.
CAUTION: Do not use any solvent (for oxamptc,
conventional record cleaner, spray thinner, ben-
zine, etc.) to clean a CD.
Moisture Condensation
Moisture may condense on the lens inside the
Unit in the following cases: Capstan ——“—
¢ After turning on heating in the room. Record/Play head
¢ Inadamp room.
¢ Ifthe Unit is brought directly from a cold to e Ifthe heads become magnetized, the Unit will produce noise. or
awarm place. lose high frequency notes.
Should this occur; the Unit may malfunction. If ¢ To demagnetize the heads, turn off the Unit, and use a head
this: tiappens, leave it turned on for a fewhours: demagnetizer (available at electronics and record shops).
until the moisture evaporates; unplug the AC
power cord, and then plug it in again.
Pinch roller
Erase head
General es
To ensure top performance, keep your CDs and the mechanism clean.
¢ Store CDs in their cases, and keep them in cabinets or on
shelves.
¢« Keep the CD holder-ciosed when not in use.
12
1-26