JVC RC-QN1 - Page 18

| Press the. (/| button to turn off the Unit.
To contin the timer settings (ON/OFF time and volume
level), turn on the power, press the CLOCK/TIMER button for more
than 2 seconds, and press the CLOCK/TIMER button repeatedly.
To change the timer setting, repeat the setting procedure from
the beginning.
CAUTION: If the Unit is unplugged, or a power fail-
ure occurs, the timer setting will be lost after ap-
prox. five minutes. You will need to reset-the-.
clock first, then the timer.
To cancel the Daily Timer, turn off the Timer indicator as follows:
LOCK TRAER Ny CLOCKTIVER:
—> — _
(Hold for 2 seconds) (2 time)
ress the CLOCK/TIMER button on the Unit
for more than 2 seconds.
Turn the JOG dial until the “@)or ” indicator
blinks on the display.
Press the CLOCK/TIMER bution.
The Timer indicator and the CLOCK indicator go out.
To re-activate the cancelled timer, repeat the same steps as for
setting the Daily Timer.
RC-QN1/QN2/QN3
incumber of
minutes when it is playing. By setting the Sleep Timer, you can fall
asleep to music and know that your Unit will tum off by itself rather
than play all night.
-You.can only set the Sleep Timer when the Unit is on and a
source is playing.
Use the Sleep Timer to turn the Unit off after-a certai
play pac* a ‘GD, tune i in rte a desired sta-
Control.
The “SLEEP” indicator lights up.
Set the length of time you want the sourc
to play before shutting off.
« Each time you press the SLEEP button, it changes the
number of minutes shown on the display in this sequence:
— 30 — 60 — 90 - 120 — Cancelled — (back to the begin-
ning)
The display will stop blinking after 5 seconds and return to the dis-
play before you set the Sleep Timer.
The Unit is now set to turn off after the number of minutes you have
set.
To Confirm the Sleep Time
When the SLEEP button is pressed, the remaining sleep time is dis-
played. After 5 seconds the original display returns.
To Cancel the SLEEP Timer Setting
Press the SLEEP button until the “SLEEP” indicator goes off on the
display.
Turning off the Unit also cancels the SLEEP Timer.
WE If you are setting the Daily Timer, the Unit will be turned on at
the set time to wake you up.
Using a microphone (not supplied), you can mix the microphone
sound with a source sound.
‘Connect a microphone by plugging it into
the MIC jack on the back of the Unit.
Start a source; CD, tape, or tuner.
Adjust the volume level, as you sing into
the microphone.
‘Connect a microphone by plugging it into
the MIC jack on the back of the Unit.
Adjust the volume level, as you sing into
the microphone.
MIC jack
Note: If “howling” occurs, keep the microphone away from the
Unit.
Shae,
ce
level, as you sing into
the
microphone.
To record, follow the steps in “Recording
from the Radio” or “Recording Pec the cp”
according to the source you want to mix.
(See pages 8 and 9.)
Note: If “howling” occurs, keep the microphone away from the
Unit.
117
1-25