8
Getting Started
English
Connecting an MD Recorder, etc (Digital Output)
Remove the cap and connect an optical digital cord (not supplied) between the System’s CD DIGITAL OUT terminal and the
input terminal of the MD recorder, etc.
You can record the digital output signal from the System’s CD Player to the MD recorder, etc.
Connecting the AC Power Cord
Firmly insert the supplied AC power cord into the AC inlet on the back of the Unit.
CAUTIONS:
• ONLY USE THE JVC POWER CORD PROVIDED WITH THIS SYSTEM
TO AVOID MALFUNCTION OR DAMAGE TO THE SYSTEM.
• BE SURE TO UNPLUG THE POWER CORD FROM THE OUTLET
WHEN GOING OUT OR WHEN THE SYSTEM IS NOT IN USE FOR AN
EXTENDED PERIOD OF TIME.
Installing the Unit on the Stand
You can place the Unit vertically by attaching the supplied Stand.
• Avoid an unstable place when placing the Unit vertically. Select a place on the level surface.
Attach the Stand to the Unit and tighten the screw. Attach the Legs to the Stand.
CD DIGITAL
OUT
MD recorder, etc. (not supplied)
Optical digital cord (not supplied)
Cap
AC IN
Screw (supplied)
Stand (supplied)
Legs (supplied)
Back of the Leg
VS-DT2000[US-UW]_EN.book Page 8 Friday, March 8, 2002 3:09 PM
To Next Page
Loading...
Need help?
General
