JVC SX-XD33 - Joining Speaker Section and Leg

– 6 –
Joining the leg and the speaker unit
6 Insert the speaker cord into the speaker
terminal inside the leg.
1 Press and hold the clamp.
2 Insert the exposed core of the speaker
cord fully into the terminal.
• Connect the cord with black stripe to the ·
terminal.
3 Release your finger.
7 Join the speaker section and the leg.
Insert the speaker section to the leg, then fix the speaker
section and the leg with one of the washers and one of the
supplied screws (short: M5 x 12 mm).
Repeat the procedure from step 1 to assemble the other
satellite speakers.
For disassembly:
Reverse Assembly procedure:
1) Remove the speaker section from the leg.
2) Remove the leg from the stand.
Assembly (continued)
Speaker
section
Leg
The cord with
the black stripe.
12
3
Joint here
without gap.
Screw
Leg
Speaker
section
Washer
Push cords fully
inside the leg before
attaching the
speaker section.
EN_SX-XD33_ff.p65 02.9.19, 11:56 AM6