11
Playing Audio via BT Connection
1. Use either Power/standby button on the SoundBar or the "INPUT" button on the remote to activate BT mode.
A Blue LED indicator will indicate that BT mode has been selected.
2. Turn on Bluetooth of your device, search for " TH-S331B " on your Bluetooth list, and then select Bluetooth connection.
3. When successfully paired, you will hear a tone and the blue LED mode indicator will stay on.
4. Use the volume buttons on the sound bar or on the remote controller to adjust the volume.
3. When mode indicator light on, press Standby or Power button button to turn off; when the indicator light off, press
any button on the remote control to turn on it.
4. Volume value: the volume value is 00-32, and the factory set value is "10". It has last volume memory function.
When pressing the Vol- or Vol+ on the soundbar or remote, the volume indicator will be flickering and scrolling.
5. When pressing the Treb/Bass/EQ mode on the remote, the mode indicator will be flickering once.
1. The unit will automatically switch to standby mode when no audio input is received for 20 minutes. The soundbar
will wake up from standby mode when any button is pressed or source input is received.
2. If the TV or the external unit is disconnected, switch it off
• To switch the unit off completely, remove the adapter from the mains socket.
• Please turn the unit off completely to save energy when not in use.
3. During operation, the volume indicator and mode indicator light will be on.When there is no operation,
the volume indicator will automatically go off after 3-5 seconds. The mode indicator will dim.
Powering On/Off
Auto Standby
1. Plug the adapter cord of the soundbar into a wall outlet, it will automatically enter standby mode;
The LED indicator will turn on red.
2. Press the STANDBY button on the soundbar or POWER button on the remote control to
turn the soundbar on. Make your selection of the desired input modes by pressing the INPUT button on the
remote control or the standby button on the soundbar.
3. To turn off, press and hold the STANDBY button or POWER button on remote control for about 2 seconds,
the soundbar will enter standby mode and LED indicator will turn on red, and then unplug it from the wall outlet.
To Next Page
Loading...
Need help?
General
