JVC UX-A4 - Disassembly of CD Player Assy and Front Panel Assy; Metal Cover; Front Panel Assy; CD Player Assy

| UX-A4 B/E/G/GI/EN
™ Disassembly of CD Player Ass’y and Front Panel Ass’y
© Metal Cover (Fig. 7-8)
1.
Remove
the
four
screws
@)
retaining
the
metal
cover
7.
From
the
connector
CN704
on
the
LCD
microcomputer
from
the
body.
PC.
board,
dismount
the
door
switch
PC.
board
attached
2. Remove the one screw 6) retaining the metal cover from to the CD player ass’y and the #6PIN connector outgo-
the back surface of the body. ing from the door motor PC. board.
3. Dismount the metal cover while expanding it outward. 8. From the connector CN706 on the LCD microcomputer
© Front Panel Ass’y (Fig. 7-8) P.C. board, discmount the card wire outgoing from the
From the connector CN701 on the LCD microcomputer connector CN601 on the CD amplifier P.C. board attached
PC. board, remove the card wire outgoing from the to the CD player ass’y.
connector CN708 on the operation key switch PC. board 9. From the connector CN705 on the LCD microcomputer
attached to the front panel ass’y, and separate the card PC. board, dismount the #PIN parallel wire outgoing from
wire from the front panel ass’y. FW501 on the CD amplifier PC. board.
© CD Player Ass’y (Fig. 7-8 ~ 11)
1. After turning the body upside down, insert a minus screw
driver into the hole @ engaging the system wire
inserting wire holder and the rear cover, and disengage
the holder and cover. Then, dismount the wire holder
while pulling it out.
2. Remove the two screws retaining the rear panel from
the body.
3. After inserting a minus screw driver between the four
engagement points ©) fixing the rears cover, release the
engagements and separate the rear cover from the body.
4. After inserting a minus screw driver between the front
panel and chassis, release the four engagement points System wire holder
() fixing the front panel ass’y, and separate the front Fig. 7-9 Fig. 7-10
panel ass’y from the body. :
5. Remove the two screws @) retaining both sides of the
CD player ass’y from the chassis.
6. After expanding the right and left sides of the chassis
outward, release the right and left engagements @) of =
the CD player ass’y and chassis, and separate the CD Z a
player ass‘y from the body.
Front panel
Rear cover
System wire
System wire holder
Fig. 7-11
@ Analytic Drawing (3) Parts List [Ml [3]
BLOCK NO. MSMM TTT]
lal REF. | PARTS NO. PARTS NAME REMARKS SUFFIX
SDSF30082 SCREW CD+CHASSIS UNIT 2
VJC2411-004 METAL COVER
TO DECK,“AMP SDST3006M SCREW
CLASS 1 LABEL
FOOT
T.SCREW
WIRE HOLDER
REAR PANEL(CT)
NAME PLATE
T.SCREW
T.SCREW
WIRE HOLDER
SYSTEM WIRE ASY
VND4221-001 METAL COVER
VJ F 4003-003
SBSF3008N
VYH7707-001
VJG1137-001
VYN9214-001
SBSF3008N
SBSF3008N
EMV7130-017
VMPO0092-001
SYSTEM WIRE 94H
COON AME WN
FOR SYSTEM WIRE
JWFOL
Fig. 7-8
ae rea ee
(No. 1890) 29