JVC UX-A4 - Reel and Actuator motor assembly; Leaf switch board

CD Amplifier P.C. Board (Fig. 7-14, 15)
. Remove the three screws 66) retaining the CD amplifier
PC. board from the CD player ass’y.
. From the optical pickup unit P.C. board, pull out the card
wire outgoing from the connector CN501 on the CD
amplifier PC. board.
. From the connector P0O11 on the spindle feed motor PC.
board, dismount the #6PIN connector outgoing from the
| UX-A4 B/E/G/GI/EN UX-A4 B/E/G/GI/VEN |
®@ CD Mechanism Ass’y (Fig. 7-14, 16)
By removing the three screws ( 65) x 2 and x 1)
simultaneously retaining the CD mechanism, rear and
front brackets, separate the CD mechansim ass’y (from
the brackets).
CD Door Motor Ass’y (Fig. 7-14, 16 ~ 18)
insert a minus screw driver into the positions ) and @
when the right and left CD door assemblies and CD cases
are engaged, and dismount the CD door assemblies.
© CD Door Motor Ass’y (Fig. 7-14, 16)
Remove the two screws retaining the CD door
assemblies from the CD cases.
connector CN502 on the CD amplifier P.C. board.
56
To LCD Board
CNT706
To LCD Board
CD amplifier P.C.board
To LCD Board
56 CN705
Fig. 7-15
CD door
.
CD case
My
CD mechanism
Rear bracket
Fig.
7-16
Fig.
7-18
(No.
1890)
32