JVC UX-C7

UX-C7 B/E/G/GI/EN
(
CASSETTE
PLAYBACK
ea
Operate in the order shown
eH
AUTO REVERBE
@ Load a cassette tape with side A facing out.
@
Press
to
start
playback.
(The
power
is
switched
on
and
the
TAPE
mode
is
engaged
to
start
the
tape
playback.
© Select the reverse mode ( 3 / 2) /C2)).
© Set the DOLBY NR switch as required.
@
After
loading
a
cassette
tape,
simply
press
the
<J
or
>
button.
The
power
is
switched
on
and
the
tape
starts
playback.
@ When the tape is played back with the reverse mode set
tothe = (single side play) or <=) (both side play)
mode,
the
tape
stops
automatically
at
the
end
of
tape
after playing one side or both sides.
Music scan
@
The
beginning
of
the
current
tune
or
the
next
tune
can
be
located
using
the
music
scan
facility.
@
Press
the
&
or
<J
button
for
tape
playback.
@
Press
the
bP
or
<td
button
for
music
scan.
(Reverse (<J direction playback) A
Notes:
@
When
switching
to
tape
playback
while
playing
a
CD,
tape
sound
will
be
heard
after
a
few
seconds.
@
If
the
power
is
switched
off
while
a
tape
is
running,
it
may
be
impossible
to
remove
the
cassette.
If
this
happens,
switch
the
power
on
again
before
attempting
to
remove
the
cassette.
@® When music scanning is completed, playback will start
automatically.
@ To skip two tunes or more, repeat the above steps @
and ®,
® To the start of the tune being played back
| al
(Forward (C>) direction playback) a
Notes:
With the following types of tape, the Music Scan
mechanism may not operate correctly. This is not a
Hier use the Music Scan facility only with suitable
apes.
@ Tapes with tunes having long pianissimo passages
(very quiet parts) or non-recorded portion during tunes.
® Tapes with short non-recorded sections.
® Tapes with high-level noise or hum between tunes.
16 (No. 1898)